Get ignition spark to the right place with the Standard Distributor Cap JH-81, which carries high-voltage current from the rotor to each spark plug wire terminal. It fits many vehicles, among them the 1984-1992 Toyota 4Runner, 1980-1992 Toyota Pickup and 1980-1985 Toyota Celica, as a direct-fit replacement for the listed applications. See the Buyer's Guide tab for the full list and engine details.
- Durable carbon brush: resists wear to help extend the life of the distributor cap.
- High dielectric-strength engineering polymer: designed to resist electrical breakdown and arcing for long life.
- Solid brass terminals: resist pitting and erosion for extended life.
- Vented design: lets ozone escape, helping keep a conductive surface from forming on the inside of the cap.
- Mounting clamps included: supplied with the cap for easier installation.
A worn or cracked distributor cap may cause misfires, hard starting or rough running. Look for cracks, carbon tracking or corroded terminals, and diagnose the cause before replacing, since plug wires, the rotor or the coil can cause similar symptoms. If the cap is at fault, JH-81 replaces it. When installing, move the spark plug wires over one at a time so each stays in its correct terminal.
Interchange: 10-0137 · 2-4840
100137 · 24840 · C589 · JA948 · EP671 · 12321581 · EP671SB · 4840 · JH81T · JA948VC · 1910135020 · 1910135120 · 1910135140 · 1910135180 · 1910135190 · 1910138210
This part cross-references / interchanges with the following part numbers:
C589, JA948, EP671, 12321581, 10-0137, 2-4840, EP671SB, 4840, JH-81, JH81T, JA948VC, 1910135020, 1910135120, 1910135140, 1910135180, 1910135190, 1910138210
