Standard Ignition LX-988 ignition control module for the 1993-1994 Ford Probe V6 2.5L and other vehicles controls the ignition coils in a distributorless ignition system. This Standard Ignition control module is designed to fix the failure issues inherent in the original module.
- Copper slug heat sinks improve heat dissipation to keep heat from damaging the module
- High-temperature polymer housing reduces moisture intrusion and minimizes vibration damage
- Double wire bonds for dependable connections under intense vibration and a tough operating environment
- Durability tested for 500 thermal cycles from -40C to +125C
- Responds to a weak crankshaft position sensor signal and energizes the coils immediately for cold-weather starts
Quick facts
- Part: Standard Ignition LX-988 ignition control module
- Fits: 1993-1994 Ford Probe V6 2.5L and other vehicles
- Condition: New
Hard starting, stalling or a no-start can be signs of a failing module. Before you replace the module, rule out the crankshaft position sensor, the coils and the connector wiring, since a fault in any of them can look like a bad module. The car takes a single module, and this listing is one.
Fits
The LX-988 is a direct-fit replacement for the 1993-1994 Ford Probe V6 2.5L, the 1993-1994 Mazda 626 V6 2.5L and the 1993-1994 Mazda MX-6 V6 2.5L. If your car is not named here, open the "Vehicles it fits" section to check your exact model and engine.
Specifications
Fit and size
- Quantity per vehicle: 1
- Voltage: 12 V
- Ignition type: Distributorless
- Attachment method: Bolt on
- Connector: 1, female
- Terminals: 9, blade, male
Build and materials
- Condition: New
- Country of origin: Japan
In the box
One ignition control module. Mounting hardware, a mounting bracket, instructions and the ignition coil are not included, so plan on new mounting bolts.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is the Standard Ignition LX-988 right for a 1993-1994 Mazda 626 V6 2.5L?
Yes. Standard Ignition LX-988 fits the 1993-1994 Mazda 626 V6 2.5L. For other models and engines, open the "Vehicles it fits" section.
Does the LX-988 ignition control module come with mounting bolts or a bracket?
No. Standard Ignition LX-988 comes as the module only. Mounting hardware, a mounting bracket, instructions and the ignition coil are not included.
What voltage and connector does this ignition control module use?
This module is a 12 V unit for a distributorless ignition. It has one female connector and nine male blade terminals.
What temperature range was this module durability tested for?
This module was durability tested for 500 thermal cycles from -40C to +125C. Double wire bonds and copper slug heat sinks are built in for vibration and heat.
Is hard cold-weather starting a sign the ignition control module is going bad?
Yes, hard starting in cold weather can be one sign of a failing module. A shop can test it; this module is built to respond to a weak crankshaft position sensor signal and begin energizing the coils at once.
