Standard Ignition Distributor Ignition Pickup P/N:LX-757
$159.99
(You save)
Keep a strong, clean ignition trigger signal coming from your distributor with the Standard Ignition Distributor Ignition Pickup LX-757. This pick-up assembly is a direct-fit replacement for the 1993-1995 Toyota 4Runner and 1993-1995 Toyota Pickup with the L4-2.4L engine. Inside the distributor, the pickup senses the rotating trigger and sends the timing signal the ignition system uses to know when to fire — if a failed pickup is the cause of your no-start or misfire, this replaces it.
Copper windings & permanent magnets: built to produce a strong signal for dependable ignition triggering.
High-temperature enameled wire: specified for better insulation and performance in the distributor's under-hood heat.
OE ignition build: from a global manufacturer of original-equipment ignition products, with quality control maintained from componentry to finished assembly; designed to address the inherent failure issues seen in the original units.
Connector: one female connector with two male blade terminals. Coil is not included.
Country of origin: Taiwan. Manufacturer part number LX-757 (also LX757).
This part cross-references / interchanges with the following part numbers:
ME662, JA1006, MP219, LX-757, 1925035010
Frequently Asked Questions
What does the LX-757 distributor ignition pickup do?
It's the signal generator inside the distributor: its windings and magnet sense the rotating trigger and send the timing signal the ignition system uses to determine when to fire.
Which vehicles does this pickup fit?
It's a direct-fit replacement for the 1993-1995 Toyota 4Runner and 1993-1995 Toyota Pickup with the L4-2.4L engine. See the Buyer's Guide tab to confirm your vehicle.
Is an ignition coil included?
No. The catalog lists Coil Included: No, so this listing supplies the distributor pick-up assembly only.
What are signs this pickup may need replacing?
Signs may include intermittent stalling, no-start, or misfire from a weak or lost trigger signal. These can have other causes, so diagnose the source before replacing.
What connector and terminals does it use?
It has one female connector with two male blade terminals, matching the original assembly's connection.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Distributor Ignition Pickup P/N:LX-757
Distributor Pick-Up AssemblyAs a global manufacturer of original equipment ignition products, we maintain complete quality control throughout the manufacturing process from componentry to finished...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
