Standard Ignition Door Window Switch P/N:DWS-1147
Standard Ignition DWS-569 front door window switch for the 2007-2010 Jeep Wrangler sends your command to the power window motor. It is a power window switch built specifically for Jeep vehicles.
A window that moves slowly, works only on some presses or does not respond can mean the switch is worn. A fuse, motor or wiring fault can cause similar signs, so with the engine off, look over the switch and its connector for a cracked housing or a loose or corroded terminal before you replace it.
Engineered as an OE replacement, this door window switch fits the 2007-2010 Jeep Wrangler, and the vehicle takes one.
Fit and size
Build and materials
One door window switch.
Does the Standard Ignition DWS-569 window switch fit the 2007-2010 Jeep Wrangler?
Yes. The Standard Ignition DWS-569 is a front door window switch listed for the 2007-2010 Jeep Wrangler, and the vehicle takes one.
What do I get with the Standard Ignition DWS-569 window switch?
You get one door window switch. No other hardware or parts are listed with it.
How many terminals does the DWS-569 window switch have?
The Standard Ignition DWS-569 has 12 male blade terminals and one female connector that attaches push-on. It is a 12-volt switch.
How do I know if my front window switch is going bad?
Slow, intermittent or no window movement when you press the switch can be signs of wear. A shop can test the switch and its circuit to confirm.
What are the conductors in this window switch made of?
This door window switch has copper alloy conductors, which give good electrical conductivity with low resistive losses. Its mechanical and electrical switching performance is also tested.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.