Standard Ignition Door Window Switch P/N:DWS1611
Keep the power windows and door locks controllable from the armrest with the Standard Ignition Door Window Switch / Power Door Lock Switch (PDS233). This RIGHT-side switch drops in as a direct-fit OE-replacement for the 2007-2010 Jeep Wrangler — see the Buyer's Guide tab for engine-level fitment. It's cataloged under both the Door Window Switch and Power Door Lock Switch names.
If your existing switch has failed — buttons that respond intermittently or a window or lock that stops reacting to its switch altogether — replacing this RIGHT-side switch addresses that worn component. Diagnose the cause first, then confirm your vehicle in the Buyer's Guide before ordering.
Interchange: PDL343 · 4602678AB · PA3666
This part cross-references / interchanges with the following part numbers:
What does this switch do?
It's a door-mounted switch that controls the power window and is also cataloged as a power door lock switch, letting you operate the glass and locks from the switch buttons.
Which vehicles does the PDS233 fit?
It's a direct-fit replacement for the 2007-2010 Jeep Wrangler. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
Is this a left- or right-side switch?
It is cataloged in the RIGHT position. Verify placement against your original switch before ordering.
What interchange numbers does it replace?
It cross-references PDL343, 4602678AB, and PA3666.
What are signs this switch may need replacing?
Buttons that respond intermittently, or a window or lock that no longer reacts to its switch, can indicate a worn switch. Diagnose the cause, since wiring or the motor can also be at fault.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.