Standard Ignition Engine Coolant Temperature Sender P/N:TX151
$67.99
(You save)
Keep an accurate read on engine temperature with the Standard Ignition Engine Coolant Temperature Sender (TX151). It drops in as a direct-fit replacement for the listed applications: the 2000-2004 Volvo S40 and 2001-2004 Volvo V40. This sender monitors engine coolant temperature and sends that signal to the vehicle's temperature gauge or control circuit, so the readings you rely on stay grounded in what the coolant is actually doing.
Core job: reads coolant temperature and reports it to the instrument-cluster gauge or warning circuit.
Resistance-based signal: its output changes with coolant temperature to drive an accurate reading.
Direct-fit design: made to install for the listed Volvo applications.
Signs the sender may need replacing include an erratic, stuck, or dead temperature gauge, or readings that don't match the engine's actual state. Because those symptoms can have other causes, diagnose the circuit first; if a failed sender is the cause, this replaces it.
Interchange: WT5164 · TS5763 · 9144143 Manufacturer part number TX151.
This part cross-references / interchanges with the following part numbers:
WT5164, TS5763, TX151, 9144143
Frequently Asked Questions
What does this coolant temperature sender do?
It monitors engine coolant temperature and sends that signal to the temperature gauge or warning circuit, so your dash reading reflects the coolant's actual temperature.
Which vehicles does the TX151 fit?
It is a direct-fit replacement for the 2000-2004 Volvo S40 and the 2001-2004 Volvo V40. Check the Buyer's Guide tab to confirm it matches your vehicle.
What are the signs this sender may need replacing?
Common signs include an erratic, stuck, or dead temperature gauge, or readings that don't match the engine's state. Diagnose the circuit first, since other causes are possible.
What numbers does this part interchange with?
It cross-references WT5164, TS5763, and 9144143. The manufacturer part number is TX151.
Will replacing this sender fix a faulty gauge reading?
If a failed sender is the cause of an inaccurate or dead temperature reading, this replaces it. Confirm the wiring and circuit aren't at fault before replacing the part.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Engine Coolant Temperature Sender P/N:TX151
Temperature Sender - With GaugeAll Coolant Temperature sensors are 100% factory tested to ensure trouble-free performanceAs a global manufacturer of original equipment ignition products, we maintain...
Keep an accurate eye on engine temperature with the Standard Ignition Engine Coolant Temperature Sender TX156. It drops in as a direct-fit replacement for the 1995-1997 SAAB 900 and 1995-1997 SAAB...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
