Keep spark and fuel timing dialed in with the Standard Ignition Engine Crankshaft Position Sensor, MPN PC1173. This sensor reads the rotation and position of the crankshaft and reports it to the engine control module, which uses that signal to time ignition and fuel delivery. It fits as a direct-fit replacement for the 2004-2006 Chevrolet Epica (L6-2.5L) and the 2009 Chevrolet Epica (L6-2.5L). Shipped as a complete assembly with a rectangular connector and three male blade terminals.
Signs a crankshaft position sensor may need replacing include a hard or no-start condition, stalling, intermittent misfires, or a check engine light for a crank sensor circuit fault. Diagnose the underlying cause before replacing, since these symptoms can have other sources.
Interchange: CSS2173 · CPSB10119 · CSS11173 · 96385999 · 96414497
This part cross-references / interchanges with the following part numbers:
What does this crankshaft position sensor do?
It reads the crankshaft's rotation and position and sends that signal to the engine control module, which uses it to time ignition and fuel delivery.
Which vehicles does PC1173 fit?
It is a direct-fit replacement for the 2004-2006 Chevrolet Epica (L6-2.5L) and the 2009 Chevrolet Epica (L6-2.5L). Check the Buyer's Guide tab to confirm your vehicle.
Is this a new or remanufactured sensor?
It is a new unit, not remanufactured, and ships as a complete assembly.
What connector does it have?
It has a rectangular connector with three male blade terminals.
What are signs this sensor may need replacing?
Hard or no-start, stalling, intermittent misfires, or a check engine light for a crank sensor circuit. Diagnose the cause first, as other parts can cause these symptoms.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
