Reseal the exhaust gas recirculation joint and keep recirculated exhaust gas moving along its intended path with the Standard Ignition Exhaust Gas Recirculation (EGR) Valve Gasket VG55. It installs as a direct-fit replacement for the 1993-1997 Infiniti J30 and the 1990-1996 Nissan 300ZX.
This gasket sits at the mounting flange between the EGR valve and its mating surface, sealing that connection so exhaust gas is routed through the EGR passage rather than escaping at the joint.
Signs this gasket may need replacing include a hiss or exhaust leak at the EGR valve joint and a rough idle if a leak at this gasket is the cause. Diagnose the source of the symptom before replacing, since other components can produce the same signs.
Interchange: EVG64 · 2-2597 · 22597 · 1471930P02 · 1471930P04 · 1741930P03
Manufacturer part number VG55
This part cross-references / interchanges with the following part numbers:
What does this EGR valve gasket do?
It seals the joint where the EGR valve mounts to its mating surface, directing recirculated exhaust gas through the intended passage instead of leaking out at the flange.
What vehicles does the VG55 fit?
It is a direct-fit replacement for the 1993-1997 Infiniti J30 and the 1990-1996 Nissan 300ZX. Check the Buyer's Guide tab to confirm your vehicle.
What are signs this gasket may need replacing?
A hiss or exhaust leak at the EGR mounting joint, and a rough idle if a leak at this gasket is the cause. Diagnose the source before replacing.
When should I replace this gasket?
Replace it whenever the EGR valve is removed or serviced, since a disturbed original gasket may not reseal reliably.
What other part numbers does it interchange with?
It cross-references EVG64, 2-2597 (22597), 1471930P02, 1471930P04, and 1741930P03.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
