Replace a melted, corroded, or damaged plug at the blower motor resistor with the Standard Ignition Blower Motor Resistor Connector S2448. It is a direct-fit replacement for many vehicles, among them the 1990-2002 Honda Accord, 1995-2004 Honda Odyssey, and 1992-2001 Honda Prelude, and it is cataloged for front and rear positions. See the "Vehicles it fits" section for the full vehicle list and engine-specific details.
This HVAC blower motor resistor connector is the electrical connector that plugs into the blower motor resistor. It carries current from the vehicle harness to the resistor that sets the blower fan's speeds.
- Built to OE standards: Standard Ignition makes its components to exact OE standards in TS16949- and ISO9001-certified facilities, and designs them for specific vehicle applications.
- Tested throughout production: Each connector goes through thorough quality checks and rigorous testing at every stage of production.
- Factory-assembled for easier installation: The connector arrives pre-assembled. Wire connectors and extended lead wires are included where applicable, and it is designed to install without specialized tools.
Signs this part may need replacing include a melted, burned, or corroded connector, loose terminals, or a blower that runs intermittently or only on some speeds. Diagnose the circuit before replacing it, because the resistor or blower motor can cause the same symptoms. If the connector is the faulty part, this replaces it.
Interchange: PT2433 · CONB11261 · EC2349
This part cross-references / interchanges with the following part numbers:
PT2433, CONB11261, EC2349, S2448
Frequently Asked Questions
What vehicles does the Standard Ignition S2448 fit?
It fits many vehicles, among them the 1990-2002 Honda Accord, 1995-2004 Honda Odyssey, and 1992-2001 Honda Prelude. See the "Vehicles it fits" section for the full list and engine details.
What does a blower motor resistor connector do?
It links the vehicle's wiring harness to the blower motor resistor, carrying the current the resistor uses to set the blower fan's speeds.
What are signs the connector may need replacing?
Look for a melted, burned, or corroded connector, loose terminals, or a blower that runs intermittently or only on some speeds. Diagnose first, as the resistor or motor may also be at fault.
Does the S2448 come with wiring?
The connector is factory-assembled, and wire connectors and extended lead wires are included where applicable. It is designed to install without specialized tools.
How is this connector made and tested?
Standard Ignition makes it to exact OE standards in TS16949- and ISO9001-certified facilities. It goes through quality checks and rigorous testing at every stage of production.
