Standard Ignition UF-525 ignition coil for the 2003-2006 Mitsubishi Montero V6 3.8L sits directly on the spark plug and steps up battery voltage into the spark that ignites the fuel. This Standard Ignition coil is engineered specifically for Mitsubishi vehicles and tested to meet OE spark energy output, impedance and durability in all operating conditions.
A weak coil can show up as a misfire, a rough idle or a check engine light. Worn spark plugs, a dirty fuel injector or an intake vacuum leak can be behind a misfire too, so find the cause before buying a coil.
This is a direct-fit replacement for the 2003-2006 Mitsubishi Montero V6 3.8L, which takes six coils. This listing is one coil.
Fit and size
Build and materials
One ignition coil with its mounting bracket. Mounting hardware and a coil wire are not included, so plan on new bolts, since the old ones may not be reusable.
Does the Standard Ignition UF-525 fit the 2003-2006 Mitsubishi Montero V6 3.8L?
Yes. Standard Ignition UF-525 is a direct-fit replacement for the 2003-2006 Mitsubishi Montero V6 3.8L, which takes six coils.
Does this ignition coil come with a mounting bracket and bolts?
The mounting bracket is included, but mounting hardware is not, so plan on new bolts. A coil wire is not included either.
Is the UF-525 coil oil filled?
No. Standard Ignition UF-525 is not oil filled. High-dielectric epoxy is injected into the case under vacuum to remove air pockets and keep moisture out.
What connector does this coil-on-plug unit use?
This coil has one oval, plug-in female connector with three male blade terminals, and it runs on 12 volts.
Are the windings in this ignition coil pure copper?
Yes. The primary and secondary bobbins use 100% pure copper windings, which resist internal shorts and dielectric breakdown.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
