Ignition Control Module for 1984-1986 Dodge Conquest & More - Standard LX-577

Standard Ignition LX-577 ignition control module for the 1984-1986 Dodge Conquest 4-cylinder 2.6L and other vehicles energizes the ignition coils in a distributorless system. It is designed to correct the inherent failure issues of the original module.

• Copper slug heat sinks improve heat dissipation to protect the module from heat damage
• High-temperature polymer housing reduces moisture intrusion and minimizes vibration damage
• Double wire bonds hold connections steady under intense vibration and a tough operating environment
• Durability tested for 500 thermal cycles from -40C to +125C
• Responds to a weak crankshaft position sensor signal and begins energizing the coils immediately for starts in cold weather

Quick facts

• Part: Standard Ignition LX-577 ignition control module
• Fits: 1984-1986 Dodge Conquest 4-cylinder 2.6L and other vehicles
• Condition: New

Hard cold starts, a stumble or a no-start can mean the module is worn, though a weak ignition coil or crankshaft position sensor can be behind them too, so find the cause before you replace it.

Fits

The module is listed across a wide range of Dodge, Plymouth and Mitsubishi models, including the 1984-1986 Plymouth Conquest 4-cylinder 2.6L and the 1984-1986 Mitsubishi Starion 4-cylinder 2.6L. If your car is not named here, check its year and engine in the "Vehicles it fits" section.

Specifications

In the box

One ignition control module; the vehicle takes one. Mounting hardware, mounting brackets, instructions and the ignition coil are not included, so plan on new bolts.