Standard Ignition Ignition Lock Cylinder and Switch P/N:US-633
$448.99
(You save)
Replace a worn, sticking key cylinder and a tired ignition switch in one step with the Standard Ignition Ignition Switch With Lock Cylinder, part number US-633. This Standard Ignition switch pairs the lock cylinder and the electrical switch in a single unit. It is a direct-fit replacement for the 1998-2002 Subaru Forester. See the Buyer's Guide tab for engine details.
Global OE ignition maker: Standard Ignition manufactures original equipment ignition products worldwide and keeps quality control in-house, from componentry through the finished product.
Copper alloy conductors: Used for superior electrical conductivity with low resistive losses.
100% tested: Every unit is checked to verify both mechanical and electrical switching performance.
Built for proper fit and function: The switch line uses high-grade materials in a robust design made for the stringent demands of today's service professional.
What it does: The lock cylinder accepts your key and turns the switch through its positions. The switch then routes power to the ignition and accessory circuits and signals the starter to crank.
Signs this part may need replacing:
A key that sticks or is hard to turn
Intermittent no-crank or no-start
Dash lights or accessories cutting out when the key is moved
Stalling while driving
Because other faults can cause the same symptoms, diagnose the cause first. If the original cylinder or switch is at fault, US-633 replaces both.
US-633 is listed for the 1998-2002 Subaru Forester. See the Buyer's Guide tab for engine details.
Does US-633 include the lock cylinder?
Yes. The manufacturer describes US-633 as an ignition switch with lock cylinder, so the switch and the cylinder come together as one part.
What are signs the ignition switch may need replacing?
Common signs are a key that sticks or is hard to turn, intermittent no-crank or no-start, power cutting out when the key is moved, or stalling. Other faults can cause these, so diagnose first.
Is US-633 tested before it ships?
Standard Ignition states that its parts are 100% tested to verify both mechanical and electrical switching performance.
What part numbers does US-633 interchange with?
US-633 interchanges with CS992, KS6992, LA1081, 83121FC070 and 83121FC071.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Ignition Lock Cylinder and Switch P/N:US-633
Replace a worn key cylinder and a tired ignition switch in one step with the Standard Ignition ignition switch with lock cylinder, part number US-176, a direct-fit replacement for the 1975-1982...
Replace a worn or sticking ignition switch and lock cylinder in one step with the Standard Ignition switch US-232. It is an ignition switch with lock cylinder that routes power to the vehicle's...
Replacing a worn Quest switch? The Standard Ignition Lock Cylinder and Switch, part number US-668, combines the key lock cylinder and the ignition switch in one unit. It is cataloged as a direct-fit...
Put dependable switching back behind your ignition key with the Standard Ignition Starter Switch US-362. This electrical switch sends power to the ignition, accessory and starter circuits as the key...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
