Keep your speedometer, cruise control, and transmission shift signals reading accurately with the Standard Ignition Manual Transmission Output Shaft Speed Sensor / Vehicle Speed Sensor SC65. It reads the rotation of the transmission output shaft and sends a speed signal to the vehicle's electronics, and it drops in as a direct-fit replacement for the 1994 Nissan D21 (All). This part is cataloged under both names — Manual Transmission Output Shaft Speed Sensor and Vehicle Speed Sensor.
Speed signal source: Direct-fit OE replacement that reports output-shaft rotation to the transmission, cruise control, and speedometer circuits.
Built for the environment: High-quality materials made to withstand extreme conditions along with gunk and transmission-fluid contamination.
2-wire plug-in connector: Square, female plug-in connector with two male blade terminals; wiring harness included.
Bolt-mount fit: Bolts to the bell-housing section of the transmission case through a single mounting hole.
Tested for reliability: Subjected to extensive, rigorous testing by the manufacturer's Quality Assurance team.
Hardware and mounting brackets are not included; consult the vehicle service information for the correct fasteners and whether they may be reused. An erratic speedometer, dropped cruise control, or harsh shifting can be signs this sensor may need replacing — if a failed speed sensor is the cause, this replaces it. Country of origin: Japan.
Interchange: S8339 · SU4652 · VSS609 · 2501075P00. Manufacturer part number SC65.
This part cross-references / interchanges with the following part numbers:
S8339, SU4652, VSS609, 2501075P00
Frequently Asked Questions
What does this sensor do?
It reads the rotation of the transmission output shaft and sends a vehicle-speed signal to the transmission, cruise control, and speedometer circuits.
Will this fit my vehicle?
It is a direct-fit replacement for the 1994 Nissan D21 (All). Check the Buyer's Guide tab to confirm fitment for your vehicle.
Where does it mount?
It bolts to the bell-housing section of the transmission case through a single mounting hole using a bolt-mount attachment.
Does it include a wiring harness and hardware?
A wiring harness is included. Mounting hardware and brackets are not included; refer to the vehicle service information for the correct fasteners.
What are signs this sensor may need replacing?
An erratic or dead speedometer, cruise control that won't hold, or harsh/erratic shifting can be signs. Diagnose the cause first, since these symptoms have other possible sources.
Standard Motor Products Manual Transmission Output Shaft Speed Sensor,Vehicle Speed Sensor P/N:SC386. Fits: Toyota 4Runner, Toyota Pickup, Toyota Previa, Toyota T100.
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
