Standard Ignition Neutral Safety Switch P/N:NS-312
Standard Motor Products
Standard Ignition NS-657 neutral safety switch for the 2011-2015 Ford Explorer and other vehicles is an electrically operated switch that restores neutral safety function. It replaces a damaged switch.
A worn neutral safety switch can show up as an engine that will not crank in Park or Neutral, or one that cranks while in gear. If a worn neutral safety switch is the cause, this one replaces it. Before ordering, look over the connector and wiring with the engine off for damage, corrosion or loose bolts, since a bad plug or wire can also keep the engine from cranking. Each vehicle takes one switch, and this listing is one.
As a 2011-2015 Ford Explorer neutral safety switch, it is a direct-fit replacement made to OE spec for fit, form and function. The same switch fits the 2007-2014 Ford Edge and the 2008-2012 Ford Taurus. The fitment also takes in other Ford, Lincoln and Mercury models, so look up your own car in the "Vehicles it fits" section.
Fit and size
Build and materials
One neutral safety switch. Gaskets and mounting hardware are not included, so plan on new bolts, since the old ones may not be reusable.
Interchange: CSW554 · SU14808 · NS7059 · 7T4Z7H557A · 9E9Z7H557A · 9E9Z7H557B
This part cross-references / interchanges with the following part numbers:
Is this Edge switch right for the 2007-2014 Ford Edge?
Yes. Standard Ignition NS-657 fits the 2007-2014 Ford Edge, and the 2016-2018 Ford Edge is covered too. Each of these takes one switch.
Is this the Taurus switch for the 2008-2012 Ford Taurus?
Yes. Standard Ignition NS-657 fits the 2008-2012 Ford Taurus. This listing is a single switch, which is the quantity that car takes.
Does the NS-657 come with gaskets or mounting bolts?
No. Gaskets and mounting hardware are not included; this listing is the switch alone. Plan on new bolts, since the old ones may not be reusable.
How many wires does the NS-657 connector have?
The harness has 5 wires and ends in one rectangular male connector with five female pin terminals. The harness is 3.375 in (85.725 mm) long, and the switch bolts on.
How is this Standard Ignition switch tested?
Every unit gets 100% end-of-line testing, aimed at meeting or exceeding OE performance. Standard Ignition NS-657 is also made to OE spec for fit, form and function.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.