Keep the signal path clean between your oxygen sensor and the engine wiring harness with the Standard Ignition Oxygen Sensor Connector S3096, a factory-assembled multi-function connector that installs as a direct-fit replacement across a wide list of Acura, Honda, Isuzu, Land Rover, and Subaru models — including the 1990-2007 Honda Accord, 1999-2005 Honda Civic, 2004-2008 Acura TSX, 1999-2004 Land Rover Discovery, and 2003-2006 Subaru Baja. See the Buyer's Guide tab for the full list of covered vehicles.
- Built to OE standards: produced in facilities certified to TS16949 and ISO9001, then checked and tested throughout production for reliable performance.
- Ready-to-install pigtail: a square, single connector with four male blade terminals and four 16-gauge wires on roughly a 17.5 in (45 cm) lead; the housing measures 1-1/2 in with a 0° bend angle.
- Hassle-free connection: comes factory-assembled with wire connectors, plus extended lead wires where applicable, so no special tools are needed to splice it in.
An oxygen sensor connector links the O2 sensor's wiring to the vehicle harness so the ECU can read the sensor's feedback. Corroded, damaged, or melted terminals can interrupt that connection — if a failed connector is the cause of an intermittent sensor signal, this replaces it. Quantity needed varies by application: many vehicles use one, while some (such as the Acura TSX and the listed Land Rover models) call for two. Country of origin: Taiwan.
Manufacturer part number S3096.
This part cross-references / interchanges with the following part numbers:
PT3873, CONB11532, EC3125, S3096
