Restore proper power distribution to your rear lamps with the Standard Ignition Tail Light Circuit Board, MPN CBT106. This direct-fit board drops into the 2008-2011 Jeep Liberty, carrying the wiring and bulb sockets that route power to the tail, brake, and turn-signal bulbs in the tail light housing. When corroded traces, cracked sockets, or a burned circuit path leave one or more rear lamps dead, replacing the board is designed to bring the affected lamp functions back online.
Direct-fit replacement: engineered to install out of the box for the listed application.
Restores tail light function: renews the circuit paths and sockets that feed the rear bulbs.
OE-level performance: designed to meet or exceed OE performance so the job is done right the first time.
Tested to OE specifications: checked against OE specs to support consistent operation and long service life.
See the "Vehicles it fits" section for full application details for the 2008-2011 Jeep Liberty.
Interchange: TBC106 · 68033798AA · TCB108
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
TBC106, 68033798AA, TCB108
Frequently Asked Questions
What vehicle does this circuit board fit?
It is a direct-fit replacement for the 2008-2011 Jeep Liberty. See the "Vehicles it fits" section to confirm fitment for your vehicle.
What does a tail light circuit board do?
It holds the wiring traces and bulb sockets inside the tail light housing, routing power to the tail, brake, and turn-signal bulbs.
What are signs this circuit board may need replacing?
Dead tail, brake, or turn-signal bulbs, flickering rear lamps, or corroded and cracked sockets can indicate a failed board. Diagnose the cause before replacing.
What interchange numbers does this part replace?
It cross-references TBC106, 68033798AA, and TCB108.
Is this an out-of-the-box installation?
Yes, it is a direct-fit replacement designed to install out of the box for the listed application.
