Standard Ignition Transfer Case Oil Temperature Sensor P/N:TX379
$210.99
(You save)
Keep an eye on transfer case fluid temperature with the Standard Ignition Transfer Case Oil Temperature Sensor (TX379). It installs as a direct-fit replacement on the 2012 Ford Explorer [All], threading into the transfer case sensor port to read the temperature of the oil inside and report that signal to the vehicle's control module.
Standard Ignition builds this sensor specifically for Ford applications, so it connects through the vehicle's existing connector.
Factory-calibrated: set to an OE temperature set point for a dependable electrical signal.
Accurate response: tight-tolerance thermistor response values help keep the temperature measurement accurate.
Tested reliability: 100% factory tested and rigorously checked for consistent, out-of-the-box performance.
Simple connection: screw-in design with a single plug-in connector and two male blade terminals.
Signs this sensor may need replacing include erratic or inaccurate temperature readings, a warning message, or a stored transfer-case temperature trouble code. Those symptoms can have other causes, so diagnose the fault first — if a failed temperature sensor is the cause, this replaces it. Country of origin: Mexico.
Manufacturer part number TX379.
This part cross-references / interchanges with the following part numbers:
WT7345, CTSA375, TS7346, DG1Z12A648B, DY1201
Frequently Asked Questions
What does the TX379 sensor do?
It measures the temperature of the oil inside the transfer case and sends that reading to the vehicle's control module so it can monitor operating conditions.
Will this fit my vehicle?
TX379 is listed as a direct-fit replacement for the 2012 Ford Explorer (All engines). Check the Buyer's Guide tab to confirm it matches your vehicle before ordering.
How does it install?
It's a screw-in sensor that threads into the transfer case sensor port and connects through a single plug-in connector with two male blade terminals.
What are signs it may need replacing?
Erratic or inaccurate temperature readings, a warning message, or a stored transfer-case temperature trouble code. Diagnose the cause first, since other faults can mimic these signs.
Where is this sensor made?
Country of origin: Mexico. Each unit is 100% factory tested for consistent, out-of-the-box reliability.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Transfer Case Oil Temperature Sensor P/N:TX379
Engine Oil Temperature SensorAs a global manufacturer of automotive aftermarket products, we maintain complete quality control throughout the manufacturing processDesigned and manufactured to...
Send the ECU an accurate temperature signal with the Standard Ignition Engine Coolant Temperature Sensor / Engine Oil Temperature Sensor TX187. Mounted at the front of the engine block, it drops in...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
