Delphi Steering Tie Rod End P/N:TA5443

Be the first to review this product
$19.99
MPN: TA5443
UPC: 689604314081
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Delphi Steering Tie Rod End P/N:TA5443
Delphi Steering Tie Rod End P/N:TA5443
$19.99

Keep your steering tight and predictable with the Delphi tie rod Steering Tie Rod End (MPN TA5443), an inner tie rod end that connects the steering linkage and transfers input to the wheel while allowing for suspension travel. It's a direct-fit replacement for the 1968-1983 FIAT 124 — see the Buyer's Guide tab for engine-level detail.

Delphi applies its OE steering expertise to this aftermarket joint, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.

  • Tested to the extreme: validated below -40°C and above 120°C, and exposed to 720 hours of salt spray for OE-level performance.
  • Micron-tolerance ball stud: machined to fine tolerances for durability and smooth joint operation.
  • Fatigue tested: the tie rod is fatigue tested to guard against failure in service.
  • Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.

Delphi includes the necessary accessories for a complete job. Signs an inner tie rod end may need replacing include loose or wandering steering, uneven tire wear, and play or clunking felt through the wheel. Have an alignment performed after installation.

Interchange: 101-1543
1011543 · 4218233 · TI20010 · ES472R

This part cross-references / interchanges with the following part numbers:

101-1543, 4218233, TI20010, ES472R

Frequently Asked Questions

What vehicle does the Delphi tie rod end TA5443 fit?

It's a direct-fit inner tie rod end for the 1968-1983 FIAT 124. Check the Buyer's Guide tab to confirm the match for your specific vehicle.

Is this an inner or outer tie rod end?

This is the inner tie rod end. It connects the steering linkage and transfers steering input while allowing for suspension movement.

What are the signs my tie rod end needs replacing?

Common signs include loose or wandering steering, a clunk or play felt through the wheel, and uneven tire wear. Diagnose the cause before replacing.

How is this Delphi tie rod tested for durability?

Delphi validates it below -40°C and above 120°C, exposes it to 720 hours of salt spray, and fatigue tests the tie rod to guard against failure.

Does it come with the parts needed to install it?

Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for correct fasteners and torque specs, and have an alignment done afterward.