Transfer steering input to the front right wheel with the Mevotech TTX Tie Rod End, part number TXMS76604, a front right outer unit from Mevotech's TTX line. It fits many vehicles, among them the 2006-2012 Ford Fusion, 2007-2012 Lincoln MKZ and 2006-2009 Mercury Milan. See the "Vehicles it fits" section for the full list.
Mevotech builds its TTX line for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks. Its Labor Saver designs, tools and hardware are intended to make installation faster and easier. Here is what Mevotech TTX tie rods bring to the job:
- Sintered bearings: Patented sintered bearings are designed for longer-lasting performance.
- Locked-on boot: A patented sealing ring locks the boot onto the housing to help keep contaminants out.
- Hardware provided: A part-specific slotted castle nut and an easy-snap cotter pin come with it, and a pre-applied nylok thread adhesive helps keep fasteners secure and vibration resistant.
- Serviceable joint: A 180-degree SAE grease fitting is included, and an application-specific ball stud system uses a larger sphere.
A tie rod end links the steering linkage to the steering knuckle, and its ball stud pivots as the wheel turns and the suspension moves. Signs this part may need replacing include loose or wandering steering, clunking when turning, uneven tire wear, or a torn boot. Diagnose the cause first. If a worn outer tie rod is the problem on your car, this part replaces it. After a 2006-2012 Ford Fusion tie rod replacement, or a replacement on any other listed vehicle, have the wheel alignment checked.
Frequently Asked Questions
Is this the right 2006-2012 Ford Fusion tie rod for my car?
It is listed as the front right outer tie rod end for the 2006-2012 Ford Fusion. It also fits the 2007-2012 Lincoln MKZ and 2006-2009 Mercury Milan. Check your vehicle in the "Vehicles it fits" section.
What does a steering tie rod end do?
It connects the steering linkage to the steering knuckle. Its ball stud pivots so steering input reaches the wheel as the wheel turns and the suspension moves.
What comes with the Mevotech TXMS76604?
The tie rod end comes with a part-specific slotted castle nut, an easy-snap cotter pin and a 180-degree SAE grease fitting. The fasteners have nylok thread adhesive pre-applied.
Can this tie rod end be greased?
Yes. A 180-degree SAE grease fitting is included, so the joint can be lubricated during routine service.
What are signs a tie rod end may need replacing?
Common signs are loose or wandering steering, clunking when turning, uneven tire wear or a torn boot. Have the steering inspected to confirm the cause, and check the alignment after replacement.
