Sunsong Brake Hydraulic Hose P/N:2206121
Replace a cracked, leaking or swollen rear hose with the Sunsong brake hydraulic hose 2204674. This flexible hydraulic hose carries brake fluid pressure to the rear brake at the wheel. It is a direct-fit application for many vehicles, among them the 2006-2009 Ford Fusion, 2007-2009 Lincoln MKZ and 2006-2009 Mercury Milan. See the "Vehicles it fits" section for the full list and engine-level details.
Sunsong is a vertically integrated company that researches, develops and builds automotive fluid transfer hoses and lines. It designs its products around what installers need, and it aims to match the original part's form, fit and function.
Signs a brake hose may need replacing include a cracked, bulging or swollen outer cover, brake fluid seeping at the hose or its fittings, or a soft, spongy pedal. If a worn hose is the cause, this Sunsong brake hose replaces it. Bleed the brake system after installation.
Interchange: 1474-99464 · 073-1857 · 150.45345 · 350-54005
147499464 · 0731857 · 15045345 · 35054005 · BH620700 · SP10728 · BHA620700 · H620700 · 71446 · 6E5Z2282AA · GJ6A43810 · GJ6A43810A · GK2A43810A · BRHR7 · 382576 · BH382576 · BH142845
This part cross-references / interchanges with the following part numbers:
Which vehicles does Sunsong 2204674 fit?
It fits many vehicles, among them the 2006-2009 Ford Fusion, 2007-2009 Lincoln MKZ and 2006-2009 Mercury Milan. See the "Vehicles it fits" section for the full list and engine details.
Is this a front or rear brake hose?
The catalog lists part 2204674 for the rear position on its listed applications.
What standards does this brake hose meet?
Sunsong states its brake hoses meet or exceed DOT, Federal Vehicle Safety Standards (FMVSS 106) and SAE J1401 standards. Each hose is high-pressure tested before it leaves the factory.
Does it come with brackets or washers?
Brackets, grommets, molded plastic guards, wire clips and protective sleeves are included as required. Hoses with banjo end fittings also include new copper washers.
Do I need to bleed the brakes after installing it?
Yes. Replacing a brake hose opens the hydraulic system, so bleed the brakes to remove air. Follow the vehicle's service information for the procedure and the correct brake fluid.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.