Renew the flexible link in your rear brake circuit with the Sunsong brake hose, part number 2204971. This rear inner Brake Hydraulic Hose is a direct-fit replacement for the 2011-2014 Toyota Sienna. Sunsong precision engineers each hose to exact fit for its listed application.
A brake hydraulic hose is the flexible section of the brake circuit. It carries pressurized fluid between the rigid lines and the brake hardware while allowing for suspension and axle movement. Over time, hoses can crack, swell or leak. If a worn hose is the cause of a soft pedal or fluid loss, this unit replaces it.
Sunsong is a vertically integrated manufacturer focused on automotive fluid transfer hoses and lines, and it develops its products around what installers need. Bleed the brake system per the vehicle service procedure after installation. Engine and full application details are listed in the "Vehicles it fits" section.
Interchange: 150.44460 · 150.44464 · 350-76254
15044460 · 15044464 · 35076254 · 18J4832 · BH621598 · SP11541 · BHA621598 · H621598 · 777382 · 682886 · BH383365 · 9094702F95 · 90947A2058 · 90947A2098 · BH144630
This part cross-references / interchanges with the following part numbers:
Which vehicle does Sunsong 2204971 fit?
It is cataloged for the 2011-2014 Toyota Sienna in the rear inner position. See the "Vehicles it fits" section for full application details.
What standards does the Sunsong brake hydraulic hose meet?
Sunsong states its brake hoses meet or exceed DOT requirements, FMVSS 106 and SAE J1401. Each hose also passes a high-pressure quality assurance test before leaving the factory.
What are signs a brake hose may need replacing?
Signs include cracks, bulging, fluid seepage at the fittings, or a soft pedal. Diagnose the cause first, because other brake parts can produce similar symptoms.
Does the hose come with any hardware?
Sunsong includes brackets, grommets, molded plastic guards, wire clips and protective sleeves as required for the application, so the wearable parts are renewed along with the hose.
Do I need to bleed the brakes after installing it?
Yes. Opening the hydraulic system lets air in, so bleed the brakes per the vehicle service procedure after installing the new hose.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
