Restore firm, reliable brake feel with the Sunsong Brake Hydraulic Hose 2207055, the flexible link that carries pressurized brake fluid from the hard line to the caliper while allowing for suspension and steering movement. It installs as a direct-fit replacement for the 2011-2014 Jeep Wrangler in the front right position — see the Buyer's Guide tab for the full engine-level fitment.
- Precision engineered: built to exact fit and supplied with the brackets, grommets, molded plastic guards, wire clips, and protective sleeves required to restore worn parts to original condition.
- Standards: meets or exceeds DOT, Federal Motor Vehicle Safety Standard FMVSS 106, and SAE J1401.
- Corrosion protection: tubing manufactured from high grade steel and electroplated with a zinc coating for corrosion and rust resistance against high humidity, road salt, water, and grime.
- Tested: every hose is high-pressure quality-assurance tested before leaving the factory.
Hoses with banjo end fittings include new copper washers to help ensure proper sealing. If a cracked, swollen, or leaking hose is the cause of a soft pedal or fluid seepage, this replaces it.
Interchange: BH622078 · BHA622078 · H622078 · 777861 · 683667 · BH384280
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicle does this brake hose fit?
It is a direct-fit replacement for the 2011-2014 Jeep Wrangler in the front right position. Check the Buyer's Guide tab to confirm the engine-level fitment for your vehicle.
What does a brake hydraulic hose do?
It carries pressurized brake fluid from the rigid brake line to the caliper while flexing to allow suspension and steering movement, so pressure reaches the brake reliably.
What standards does this hose meet?
Each Sunsong brake hose meets or exceeds DOT, Federal Motor Vehicle Safety Standard FMVSS 106, and SAE J1401, and is high-pressure tested before leaving the factory.
Does it include mounting hardware?
It is supplied with the brackets, grommets, molded plastic guards, wire clips, and protective sleeves required to restore worn parts. Hoses with banjo end fittings also include new copper washers.
What are signs this brake hose may need replacing?
Cracking, swelling, bulging, or fluid seepage at the hose, or a soft or spongy brake pedal, can indicate a failing hose. Diagnose the cause before replacing.
Write a Review