Route high-pressure power steering fluid from the pump to the steering gear with the Sunsong Power Steering Pressure Line Hose Assembly 3401757. It installs as a direct-fit replacement for the 1981-1987 Toyota Land Cruiser [All], moving pressurized fluid through the steering circuit so the system can build the assist the driver commands.
- Build & fittings: CSM hose with a Male Inverted Flare fitting at each end (16 mm per end) and an overall length of 815 mm (32.1 in).
- Pressure ratings: the pressure hose is rated to a 1,500 psi max working pressure, an 8,700 psi burst pressure, and 1,600 lb tensile strength for durability.
- Factory tested: each pressure hose is checked under high pressure before it ships, supporting a trouble-free installation.
- What's included: Bracket included: No. Switch port included: No.
If a cracked, leaking, or deteriorated original pressure line is the cause of fluid loss, a whining pump, or hard steering, this assembly replaces it; diagnose the cause before ordering. Country of origin: Thailand.
Interchange: 36-358800 · 36358800 · 2647-273739 · 2647273739 · 35880 · 979-2227 · 9792227 · 71210 · 358800 · 13401757 · 72142 · 3769 · 4441060131 · 4441160131. Manufacturer part number 3401757.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does this power steering pressure line hose fit?
It is a direct-fit replacement for the 1981-1987 Toyota Land Cruiser [All]. See the Buyer's Guide tab to confirm fitment for your vehicle.
What does this part do?
It carries pressurized power steering fluid from the pump to the steering gear so the system can deliver steering assist.
What are the pressure ratings on this hose?
The pressure hose is rated to a 1,500 psi maximum working pressure, an 8,700 psi burst pressure, and 1,600 lb tensile strength.
Does this assembly include a bracket or switch port?
No. Per the catalog, Bracket Included: No and Switch Port Included: No. Transfer or replace any hardware as directed by the vehicle service procedure.
What are signs the pressure line may need replacing?
Fluid leaks or drips, low reservoir level, a whining pump, or harder steering can be signs. Diagnose the cause first, since these symptoms can have other sources.
Write a Review