Keep pressurized power steering fluid moving on the pump's high-pressure side with the Sunsong power steering pressure line hose assembly, part number 3402340. This from-pump pressure line is a direct-fit replacement for the 2006-2010 Kia Sedona and the 2007-2009 Hyundai Entourage. Sunsong builds its hose assemblies to deliver exact form, fit and function.
The pressure line carries fluid under pressure from the power steering pump to the steering gear. Signs this hose may need replacing include fluid seeping at the hose or its fittings, a wet or cracked hose, and a dropping fluid level. A low fluid level from a leak can also bring on pump whine or heavier steering effort. Other components can cause these symptoms, so find the source of the leak before replacing.
Sunsong specializes in developing and manufacturing automotive fluid transfer hoses and lines. This is a standard-replacement grade part, and each listed application uses one. Mounting brackets, washers, retainer clips, inserts, sleeves and mounts are not included, and there is no switch port. Country of origin: Thailand.
Fitment:
2006-2010 Kia Sedona — Engine: All
2007-2009 Hyundai Entourage — Engine: All
Interchange: 2647-715086 · 979-4073
37327 · 92252 · 365641 · 575104D600 · 13402340 · 575104D200 · 76488 · 55294 · 2647715086 · 9794073
This part cross-references / interchanges with the following part numbers:
Which vehicles does the Sunsong 3402340 fit?
It is listed for the 2006-2010 Kia Sedona and the 2007-2009 Hyundai Entourage (engine: All), with one pressure line used per vehicle.
What end fittings does this pressure line have?
One end has a banjo fitting and the other has a female inverted flare fitting. The assembly measures 50.3 in (1277 mm) overall.
Are washers or brackets included?
No. Brackets, washers and retainer clips are not included. Check the vehicle service information for the correct sealing washers, and transfer or replace brackets as the service procedure directs.
What pressure is the hose rated for?
Sunsong lists a 1,500 psi maximum working pressure, an 8,700 psi burst pressure rating and 1,600 lb tensile strength. Each pressure hose is tested at high pressure before leaving the factory.
What are signs of a failing power steering pressure hose?
Fluid leaking at the hose or fittings, a dropping fluid level, pump whine or heavier steering may indicate a bad hose. Other parts can cause these signs, so confirm the leak source first.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
