Help keep steering feel precise and connected with the Suspensia X13TE1456 tie rod end, a direct-fit replacement Jeep Grand Cherokee tie rod for 2011-2015 models that also fits the 2011-2015 Dodge Durango. It is cataloged for the front right outer position.
This steering tie rod end is the pivoting joint between the tie rod and the steering knuckle. It carries the push and pull of the steering linkage to the wheel while letting the knuckle turn and the suspension travel. A worn joint can develop play, so steering input no longer reaches the wheel as directly as it should.
Signs this part may need replacing include looseness or play in the steering wheel, and a knocking or clunking noise when turning. Other signs are a tendency to wander at highway speed and uneven wear on the front tire edges. If a worn outer tie rod end is the cause, this part replaces it. Inspect the steering and suspension to confirm the cause before ordering. Have the wheel alignment checked after installation, because replacing a tie rod end affects the toe setting.
Interchange: TA5466 · 68069646AA · 68069646AB · TO81062 · ES800972 · GS25621 · MS25621
This part cross-references / interchanges with the following part numbers:
Does this Jeep Grand Cherokee tie rod end fit my 2011-2015 model?
Yes. The Suspensia X13TE1456 is a direct-fit replacement for the 2011-2015 Jeep Grand Cherokee and also fits the 2011-2015 Dodge Durango. Check the Buyer's Guide tab to confirm your vehicle.
Which position does this tie rod end fit?
It is cataloged for the front right outer position, where it connects the tie rod to the steering knuckle on that side of the vehicle.
What does a tie rod end do?
It is the pivoting joint that transfers steering linkage movement to the steering knuckle, so the front wheel turns when you turn the steering wheel.
What are signs of a worn tie rod end?
Common signs include play in the steering wheel, a clunk when turning, wandering at speed and uneven front tire wear. Inspect the steering and suspension to confirm the cause before replacing parts.
Do I need an alignment after installing it?
Yes, an alignment is recommended because replacing an outer tie rod end changes the toe setting. Follow the vehicle service information for the installation procedure and torque values.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
