Suspensia Suspension Control Arm and Ball Joint Assembly P/N:X21CJ0770

Be the first to review this product
$95.99
MPN: X21CJ0770
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Suspensia Suspension Control Arm and Ball Joint Assembly P/N:X21CJ0770
Suspensia Suspension Control Arm and Ball Joint Assembly P/N:X21CJ0770
$95.99

If a SUSPENSIA control arm review pointed you here, the SUSPENSIA Control Arm and Ball Joint Assembly X21CJ0770 pairs the lower control arm with its ball joint in one direct-fit unit for the 1998-2003 Jaguar XJ8, 1998-2003 Jaguar Vanden Plas, and 1998-2003 Jaguar XJR. It installs in the front left lower rearward position, locating the wheel and letting the steering knuckle pivot through suspension travel.

This control arm and ball joint assembly combines the arm with its integrated ball joint, so worn pivot components are renewed together.

  • Integrated ball joint: built into the arm, so the pivot and its rubber dust boot are replaced in one part.
  • Front left lower rearward fit: engineered for that specific corner of the listed Jaguar applications.
  • One-piece service: replaces the arm and ball joint as a single unit rather than separate pieces.

Signs this part may need replacing include clunking on acceleration or over bumps, imprecise steering, or a cracked ball-joint boot. Diagnose the cause before ordering to confirm the arm is the source. This listing covers one assembly for the driver-side lower rearward location.

Interchange: TC8410 · JLM21303 · RK622707

This part cross-references / interchanges with the following part numbers:

TC8410, JLM21303, RK622707

Frequently Asked Questions

What vehicles does the SUSPENSIA X21CJ0770 control arm fit?

It is a direct-fit replacement for the 1998-2003 Jaguar XJ8, 1998-2003 Jaguar Vanden Plas, and 1998-2003 Jaguar XJR. Check the Buyer's Guide tab to confirm the fit for your vehicle.

Which position does this Jaguar XJ8 control arm install in?

It fits the front left (driver-side) lower rearward position on the listed applications. This listing is for one assembly.

Does this part include the ball joint?

Yes. The ball joint is integrated into the control arm, so replacing the assembly renews the arm, the ball joint, and its rubber dust boot together.

What interchange numbers does the X21CJ0770 replace?

It cross-references TC8410, JLM21303, and RK622707. Matching one of these numbers helps confirm you are ordering the correct part.

When should I replace a worn control arm?

Clunking on acceleration or over bumps, imprecise steering, or a torn ball-joint boot can be signs the arm may need replacing. Diagnose the cause first, since these symptoms can have other sources.