Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-607
$59.99
(You save)
Tighten up loose, wandering handling on the front suspension with the Dorman control arm — the Suspension Control Arm and Ball Joint Assembly, part number 520-607. It's a direct replacement for the original equipment in the front left upper position on the 1990-1993 Acura Integra (All engines), and it ships with the ball joint and bushings already installed so you can bolt it in and go.
Complete assembly: arrives with a pre-installed ball joint and rubber bushings, saving time and labor at the bench.
Cast/forged steel arm: black-finished steel construction with additional coatings that provide rust and corrosion resistance.
Threaded ball joint stud: 14 mm thread diameter, pre-greased from the factory with no separate grease fitting.
Mounting hardware included: comes with hardware, so there's no hunting for a separate Dorman control arm bolt.
This is a non-adjustable, standard-replacement arm measuring about 288.5 mm at its maximum width and 237 mm long, with a 12 mm mounting hole. If a worn upper control arm or ball joint is behind clunking over bumps, uneven tire wear, or loose steering, this assembly replaces those failed parts. Country of origin: Taiwan.
What vehicle and position does the Dorman 520-607 fit?
It's a direct replacement for the front left upper control arm position on the 1990-1993 Acura Integra (All engines). Check the Buyer's Guide tab to confirm your vehicle.
Does this control arm and ball joint assembly come with the ball joint and bushings?
Yes. Each assembly ships with the ball joint and rubber bushings pre-installed, so you replace the whole unit in one step.
Is mounting hardware included?
Yes, mounting hardware is included with this assembly. Consult the vehicle service information for the correct torque specs during installation.
Is the ball joint pre-greased, and does it have a grease fitting?
The assembly is pre-greased from the factory. It does not include a separate grease fitting.
What are signs this upper control arm may need replacing?
Clunking over bumps, uneven tire wear, or loose, wandering steering can indicate a worn arm or ball joint. Diagnose the cause before replacing, as other parts can produce the same symptoms.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-607
Help keep the front end steady and predictable with the Dorman control arm 520-520, a front right lower control arm with ball joint built to directly replace the original on the 1994-1999 Nissan...
Refresh the rear suspension of your 2003-2009 Nissan 350Z or 2003-2007 Infiniti G35 with this Dorman suspension control arm and ball joint assembly, part number 521-607, built for the rear left upper...
Help keep the wheel firmly located and the ride composed with this Dorman control arm, part number 520-472, a front right lower rearward arm that arrives with its ball joint and bushings already...
Help restore a steady, predictable front end with the Dorman control arm P/N 520-052, a front right lower suspension control arm with ball joint for the 2017-2025 Mazda CX-5. It directly replaces the...
Help bring back a stable front end under your SUV with the Dorman control arm from the OE Solutions line — this suspension control arm and ball joint assembly (MPN 520-019) is a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
