Rear Left Upper Control Arm with Ball Joint for 1996-2003 Toyota RAV4 - Delphi TC7183

Be the first to review this product
$76.99
WARNING:California Proposition 65▾
MPN: TC7183
UPC: 689604344149
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7183
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7183
$76.99

Refresh a worn rear suspension with the Delphi control arm and ball joint assembly, MPN TC7183. This Delphi control arm drops in at the rear left upper position on the 1996-2003 Toyota RAV4, pairing the arm and its ball joint in one unit. If a sloppy joint or bent arm is behind clunking, uneven tire wear, or loose handling, this assembly replaces the failed original.

  • Tested for OE performance: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close OE-to-aftermarket compatibility, tested from below -40°C to over 120°C and through 720 hours of salt spray.
  • Inspected to OE material specs: Every arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
  • Precision ball studs: Ball studs are machined to micron tolerances for durable, smooth joint operation.
  • Robot-welded & protected: Robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.

A trusted fix for 1996-2003 Toyota RAV4 control arm wear and a straightforward rear control arm replacement. See the Buyer's Guide tab for engine-level fitment.

Interchange: 102-6675 · 521-693 · 48790-42010
1026675 · 521693 · 4879042010 · CB74537 · CB74537PR · RK621736 · CMS86165

This part cross-references / interchanges with the following part numbers:

102-6675, 521-693, CB74537, CB74537PR, RK621736, CMS86165, 48790-42010

Frequently Asked Questions

Does this Delphi control arm fit a 1996-2003 Toyota RAV4?

It is a direct-fit application for the rear left upper position on the 1996-2003 Toyota RAV4. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.

What does this Delphi assembly include?

It combines the suspension control arm with its ball joint in one unit, so you replace both the arm and the joint together rather than sourcing them separately.

What are signs this rear control arm may need replacing?

Clunking or knocking over bumps, uneven or accelerated tire wear, and loose or wandering handling are common signs. Diagnose the cause before replacing.

Is the ball joint included with the arm?

Yes. The ball joint is part of this assembly, with studs machined to micron tolerances for smooth, durable joint operation.

Should I replace both sides at the same time?

Suspension arms are commonly serviced in pairs for balanced handling and even wear, but this listing covers the single rear left upper assembly. Follow the service procedure for your vehicle.