Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS9673
$85.99
(You save)
Tighten up your front end with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly CMS9673 — a direct-fit Honda Accord control arm that installs in the front left upper position. It drops in as a replacement for the 1998-2002 Honda Accord, 1999-2003 Acura TL, and 2001-2003 Acura CL; see the Buyer's Guide tab for engine-level fitment.
This control arm and ball joint assembly arrives with the ball joint already integrated, ready to bolt into the front left upper location.
Superior toughness: patented sintered bearings for longer-lasting performance.
Simple to service: includes a 90-degree SAE grease fitting.
Larger sphere design: an application-specific ball stud system with a larger sphere.
Faster fit: a part-specific nylon locking nut is provided, and a thicker, stronger flange resists deformation during installation.
Stamped steel construction is built to OE-level tolerances, and a protective surface treatment helps resist corrosion. The same part also serves as an Acura TL control arm for the listed years. As the front left upper unit, it locates the wheel and pivots the steering knuckle; if a worn ball joint or bushing on the original is the cause of clunking over bumps, wandering steering, or uneven front tire wear, this assembly replaces it. Replace the matching arm on the other side for balanced handling.
Frequently Asked Questions
What vehicles does the CMS9673 fit?
It's a direct-fit front left upper replacement for the 1998-2002 Honda Accord, 1999-2003 Acura TL, and 2001-2003 Acura CL. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Is this a Honda Accord upper control arm or a lower one?
This is a Honda Accord upper control arm — the catalog lists it in the front left upper position. It is not a lower control arm.
Does it include the ball joint and installation hardware?
Yes. The ball joint is integrated into the assembly, and it comes with a 90-degree SAE grease fitting and a part-specific nylon locking nut for installation.
Will this fit a 2000 Honda Accord control arm?
Yes — the 2000 Honda Accord falls within the 1998-2002 Accord coverage for the front left upper position. Confirm your engine in the Buyer's Guide tab.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking or knocking over bumps, wandering or loose steering, and uneven front tire wear. Have the cause diagnosed first, since these symptoms can have other sources.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS9673
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS70110. Fits: Audi A6, Audi A6 Quattro, Audi A8 Quattro, Audi S6, Audi S8, Volkswagen Phaeton.
Keep the front end tight and the steering precise with the Mevotech Supreme control arm CMS101145, a front left lower suspension control arm and ball joint assembly built as a direct-fit replacement...
Firm up steering response and restore tight front-end geometry with the Mevotech Supreme Control Arm with Ball Joint CMS251267 — a front left upper control arm and ball joint assembly that installs...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
