Front Right Lower Control Arm with Ball Joint for 2004-2009 Mazda 3 & More - Delphi TC1450

Whether you need a 2004-2009 Mazda 3 control arm or a replacement for a 2006-2010 Mazda 5, the Delphi Control Arm with Ball Joint TC1450 is designed to help keep your front suspension tight and your steering steady. It is a direct-fit replacement for the front right lower position on the listed applications. Delphi brings the expertise behind its OE safety technology, fitted to millions of vehicles worldwide, to its aftermarket steering line. Its dimensional and material analysis is aimed at close compatibility between the original part and this one.

• Tested to the extreme: Delphi tests its parts at temperatures below -40°C and above 120°C and exposes them to 720 hours of salt spray.
• Checked and robot-welded: every Delphi control arm goes through 100% crack detection and ultrasonic flaw detection to confirm the materials match OE specifications. Robot welding gives consistent performance and quality.
• Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
• Anti-corrosion protection: applied to each part to help prevent corrosion and give a clean finished appearance.

The lower control arm links the wheel knuckle to the vehicle's chassis and lets the suspension travel up and down. The ball joint gives the knuckle a pivot point for steering. Because this is a control arm and ball joint assembly, the arm and the joint are replaced together in one piece. Signs this part may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and excess play in the ball joint. If a worn arm or ball joint is the cause, this assembly replaces both. Have the wheel alignment checked after installation.