Restore precise steering and a solid, controlled ride with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-6655. This front right lower control arm arrives with its ball joint pre-assembled for a complete installation, and it drops in as a direct-fit replacement for the 2005-2008 Hyundai Tiburon (see the Buyer's Guide tab for engine details).
The lower control arm locates the front wheel and, through its ball joint, allows the steering knuckle to pivot and travel with the suspension. Signs the original may need replacing include clunking or knocking over bumps, uneven tire wear, and loose or wandering steering. If a worn control arm or ball joint on this Tiburon is the cause, this assembly replaces it.
Interchange: 1016655 · 8500383 · 62251050 · 521754 · 545012C602AS · 545012C607 · RK620519 · FA3438 · CMS901020
This part cross-references / interchanges with the following part numbers:
What vehicle does this control arm fit?
It is a direct-fit replacement for the 2005-2008 Hyundai Tiburon. Check the Buyer's Guide tab to confirm the exact application for your vehicle.
Does it come with the ball joint?
Yes. The control arm ships with the ball joint pre-assembled for a complete installation, so both wear points are replaced together.
What position is this control arm?
It is the front right lower control arm and ball joint assembly for the listed application.
Is any hardware or bushing included?
New hardware and bushings are included where applicable. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are signs my control arm or ball joint needs replacing?
Common signs include clunking or knocking over bumps, uneven tire wear, and loose or wandering steering. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
