Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Help keep the front end steady and predictable with this Dorman control arm with ball joint, part number 520-490. It installs as a direct replacement for the original front right lower arm on the 2005-2011 Ford Focus, which makes it a straightforward 2005-2011 Ford Focus control arm repair. See the "Vehicles it fits" section for engine details.
This Dorman suspension control arm and ball joint assembly directly replaces the original equipment on the listed applications, so there is no separate ball joint or bushings to source.
As a Dorman lower control arm for the front right position, it connects the steering knuckle to the chassis. It lets the wheel travel with the suspension while helping hold its position. The arm may need replacing if you notice clunking over bumps, loose or wandering steering, or uneven tire wear. Other suspension parts can cause the same symptoms, so diagnose the cause first. The arm is sold individually, and replacing both lower arms together is recommended. A wheel alignment is advised after installation.
Interchange: 810-232278B · 622.61004 · 623.61004
810232278B · 62261004 · 62361004 · CA8568 · 4S4Z3078AA · 6S4Z3078AA · 7S4Z3078A · 8S4Z3078A · 9S4Z3078A · CK80407 · K80407 · RK80407 · FA4393 · GK80407 · CMK80407 · MCSOE119 · MCSOE48 · MCSOE98 · 2605497 · 2605497M · 5CB40060 · SRK80407 · X15CJ0388 · JTC1537
This part cross-references / interchanges with the following part numbers:
What does this control arm do?
It connects the front right lower corner of the suspension to the chassis and carries the ball joint that pivots with the steering knuckle. This helps hold wheel position as the suspension moves.
Does it fit my 2005-2011 Ford Focus?
It is listed as a direct replacement for the front right lower position on the 2005-2011 Ford Focus. Check the "Vehicles it fits" section for engine details.
What comes with it?
The arm arrives with the ball joint and bushings pre-installed. Consult the vehicle service information for the correct fasteners and whether the originals may be reused.
What are signs the lower control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause first, since other suspension parts can produce similar symptoms.
Should I get an alignment after installing it?
Yes, a wheel alignment is recommended after replacing a control arm. Replacing both lower arms at the same time is also recommended.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.