Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-932
Help your front suspension ride smoothly and track true with the Dorman control arm, part number 521-073, a front left lower control arm with the ball joint and bushings already installed. It is built as a direct replacement for the original equipment on the 2007-2015 Mini Cooper. See the Buyer's Guide tab for engine and trim details.
Dorman puts this assembly through an industry-leading evaluation process aimed at a smooth ride, directional stability and predictable handling.
Signs a lower control arm or its ball joint may need replacing include clunking over bumps, loose or wandering steering, and uneven tire wear. If a worn ball joint or bushing on the front left lower arm is the cause, this Dorman suspension control arm and ball joint assembly replaces the whole unit in one piece. A wheel alignment is recommended after installation, and the vehicle service information should be consulted for the correct fasteners and torque values.
Interchange: 102-7603
1027603 · 31124048627 · 31126772301 · TC2330 · CA8631 · 5CB10454 · RK621263 · GS101113 · CMS101113 · 2606571 · 1502029
This part cross-references / interchanges with the following part numbers:
Does this Mini Cooper control arm fit my car?
It is listed as a direct replacement for the 2007-2015 Mini Cooper in the front left lower position. Check the Buyer's Guide tab to confirm your exact configuration.
What does a Dorman lower control arm do?
It links the wheel assembly to the vehicle so the suspension can move up and down while helping keep the wheel located. Its ball joint provides the pivot point for steering.
What comes with part 521-073?
The arm comes with the ball joint and bushings already installed, so there is no need to press them into the arm separately.
What are signs the front lower control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Inspect the ball joint and bushings to confirm the cause before replacing.
Do I need an alignment after installing it?
A wheel alignment is recommended after replacing a control arm. Consult the vehicle service information for the correct fasteners, torque values and whether original fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.