Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC514
Keep your BMW's front suspension precisely located with the Delphi control arm and ball joint assembly TC2227, a direct-fit replacement for the front left lower forward position on the 2007-2018 BMW X5 and 2008-2019 BMW X6. It locates the wheel, sets suspension geometry, and its integrated ball joint lets the steering knuckle pivot through travel — worn bushings or a loose joint can show up as clunking on acceleration or over bumps, wandering steering, or uneven tire wear.
Features:
Delphi carries its OE steering expertise into the aftermarket, so if you've been checking Delphi control arm reviews before replacing a worn X5 control arm, this front left lower forward assembly is a direct-fit for the listed BMW applications.
Interchange: 3112 6773 949 · 31 12 6 791 395 · 31 12 6 863 169 · 101-7038 · 102-7038 · 102-7039 · 521-161 · 521-162 · 524-849
31126773949 · 31126791395 · 31126863169 · 1017038 · 1027038 · 1027039 · 521161 · 521162 · 524849 · CB15063PR · CB14353 · CB14353PR · CB15063 · CK620798 · K620798 · RK620798 · RK620799 · CMS101143 · GS101143 · MS101143 · JTC1456
This part cross-references / interchanges with the following part numbers:
Is this the right Bmw X5 control arm for my vehicle?
It's a direct-fit front left lower forward control arm and ball joint assembly for the 2007-2018 BMW X5 and 2008-2019 BMW X6. Check the Buyer's Guide tab to confirm your exact year.
What position on the vehicle does the TC2227 fit?
It fits the front left (driver's side) lower forward control arm position. The right side uses a different assembly, so verify the corner you're replacing.
Does this Delphi control arm include the ball joint?
Yes. The ball joint is integrated into the assembly, with ball studs machined to micron tolerances for smooth operation, so you replace the arm and joint as one unit.
What are the signs this control arm may need replacing?
Common signs include clunking on acceleration or over bumps, wandering or loose steering, and uneven tire wear. Have the suspension inspected to confirm the cause before replacing.
How is this Delphi part tested for quality?
Delphi tests to OE performance levels: exposure below -40°C and above 120°C, 720 hours of salt spray, plus 100% crack and ultrasonic flaw detection to match OE specifications.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.