Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-997
Dorman 521-105 front left lower control arm with ball joint for the 2012-2021 Toyota Prius c and other vehicles connects the front left wheel to the chassis and lets it move with the suspension.
Clunks over bumps, loose steering or uneven front tire wear can mean this arm, its ball joint or its bushings are worn, though a worn tie rod end or strut mount can be behind them too. Each car takes one on each side of the front axle, and the pair is normally replaced together; this listing is the front left only, and the front right is a separate part.
It fits the 2012-2021 Toyota Prius c, the 2006-2019 Toyota Yaris and the 2008-2014 Scion xD. This Dorman suspension control arm and ball joint assembly is a direct replacement for the original equipment on these vehicles.
Fit and size
Build and materials
One control arm with the ball joint and bushings installed. Mounting hardware is included.
Interchange: 102-5766 · 810-256918B · 623.44054
TC2463 · CA14400 · 4CB80065 · RK620572 · GS86138 · CMS86138 · 2605959 · SK521105 · 1525021 · X50CJ4073 · JTC7654 · 4806909140 · 4806959095 · 4806959125 · 4806959135
This part cross-references / interchanges with the following part numbers:
Is the Dorman control arm 521-105 the right one for a 2012-2021 Toyota Prius c?
Yes. Dorman 521-105 is a front left lower control arm with ball joint for the 2012-2021 Toyota Prius c. The right side is a separate part.
Is this Dorman lower control arm the one for the 2006-2019 Toyota Yaris?
Yes. Dorman 521-105 fits the 2006-2019 Toyota Yaris in the front left lower position.
Do the Dorman control arm bushings come pre-installed?
Yes. This control arm arrives with the ball joint and rubber bushings already installed, and mounting hardware is included.
Is this Dorman suspension control arm made of steel?
Yes. Dorman 521-105 has a steel control arm with rubber bushings, and additional coatings give it rust and corrosion resistance.
Is the ball joint on this control arm pre-greased?
Yes, the ball joint is pre-greased and installed on the arm. The assembly has no grease fitting, and the ball joint stud is threaded with a 14 mm thread diameter.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.