Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5653
$54.99
(You save)
Steer with confidence and keep your suspension geometry in check with the Delphi control arm assembly TC5653, a direct-fit replacement for the 2010-2015 Chevrolet Camaro. This unit locates the front right lower rearward position, combining the control arm with a pre-installed ball joint so you replace the whole hinge point at once. If a worn arm or joint is causing looseness, clunks over the road, or uneven tire wear on your Camaro, this Chevrolet Camaro control arm addresses that job.
OE-derived engineering: Built on Delphi's OE safety technology fitted to millions of vehicles worldwide; tested to the extreme, withstanding temperatures below -40°C and above 120°C plus 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: Each control arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision joint: Ball studs machined to micron tolerances for durability and smooth joint operation.
Built to last: Robot welding for consistent quality, and anti-corrosion protection applied for corrosion prevention and enhanced appearance.
Shoppers researching Delphi control arm reviews and comparing Camaro control arm options will find this control arm and ball joint assembly built to Delphi's OE-focused standard.
What vehicles does the Delphi TC5653 control arm fit?
It is a direct-fit replacement for the 2010-2015 Chevrolet Camaro. See the Buyer's Guide tab to confirm the correct engine and configuration for your vehicle.
Which position on the vehicle is this control arm for?
This assembly fits the front right lower rearward position. It combines the control arm and ball joint into one unit for that location.
Does this include the ball joint?
Yes. It is a control arm and ball joint assembly with the ball joint already installed, so you replace both the arm and the joint together.
What are the signs this control arm may need replacing?
Common signs include clunking on acceleration or over bumps, steering looseness or wander, and uneven front tire wear. Have the cause diagnosed before replacing.
How is the Delphi TC5653 built for durability?
It uses ball studs machined to micron tolerances, 100% crack and ultrasonic flaw detection, robot welding, and anti-corrosion protection, tested from below -40°C to above 120°C.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5653
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
