Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5868
$147.99
(You save)
Tighten up your rear suspension with the Delphi control arm (TC5868), a direct-fit replacement for the 2006-2012 Hyundai Santa Fe, 2007-2012 Hyundai Veracruz, and 2011-2013 Kia Sorento. Cataloged as the rear left upper unit, this control arm and ball joint assembly locates the wheel through its travel while the integrated ball joint lets the suspension articulate — so a single part replaces both a worn arm and a worn joint.
OE-grade validation: tested from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
Inspected to spec: 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision studs: ball studs machined to micron tolerances for durability and smooth joint operation.
Built consistent: robot-welded for repeatable quality, with anti-corrosion protection applied to each part.
If a worn rear arm or ball joint is behind clunking over bumps, a loose or wandering feel, or uneven tire wear on your Hyundai Santa Fe control arm setup or Kia Sorento control arm, this Delphi unit replaces it. Have an alignment checked after installation.
It's a direct-fit rear left upper control arm for the 2006-2012 Hyundai Santa Fe, 2007-2012 Hyundai Veracruz, and 2011-2013 Kia Sorento. See the Buyer's Guide tab to confirm your vehicle.
Does this include both the control arm and the ball joint?
Yes. TC5868 is a complete assembly, so the control arm and its ball joint come together as one serviceable unit.
Which corner of the vehicle is this for?
It's cataloged as the rear left upper position. Confirm the location that applies to your vehicle before ordering.
What are signs my control arm or ball joint may need replacing?
Common signs include clunking or knocking over bumps, a loose or wandering feel, and uneven tire wear. Diagnose the cause first, since other suspension parts can produce similar symptoms.
Will this fit a 2012 Kia Sorento?
Yes — the 2012 Kia Sorento control arm application is covered within the 2011-2013 Sorento fitment for this rear left upper assembly. Check the Buyer's Guide to verify your configuration.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5868
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Steer straight and keep the front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC3986), a direct-fit Tacoma lower control arm for the 2016-2022 Toyota Tacoma. It...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
