Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:521-717
Dorman 521-891 front left lower control arm with ball joint for the 2010-2015 Chevrolet Cruze and other vehicles holds the front left wheel to the vehicle body and lets it move with the suspension. This Dorman suspension control arm and ball joint assembly directly replaces the original assembly on specific vehicles.
A clunk over bumps, a front end that wanders or uneven front tire wear can mean the arm, its bushings or its ball joint are worn. Sway bar links, tie rod ends and wheel bearings can be behind those signs too, so find the cause before buying.
The 2010-2015 Chevrolet Cruze, the 2012-2017 Buick Verano and the 2016 Chevrolet Cruze Limited take this arm, and it fits more vehicles besides. Open the Buyer's Guide tab to check your exact model and engine. On the 2010-2015 Chevrolet Cruze this listing is one arm for the front left; the front right is a separate part and is normally replaced at the same time.
Fit and size
Build and materials
One control arm with ball joint and mounting hardware. A grease fitting is not included.
Interchange: 810-497332B · 623.62002
TC2587 · 13272605 · 13334022 · 13463244 · RK621752 · GS501133 · CMS501133 · 2606754 · 2606754M · 5CB50324 · SK521891 · 1503039 · X07CJ1149 · JTC1477 · V510073
This part cross-references / interchanges with the following part numbers:
Is this Dorman lower control arm right for the 2010-2015 Chevrolet Cruze?
Yes. Dorman 521-891 is the front left lower control arm for the 2010-2015 Chevrolet Cruze. The front right side is a separate part.
Does this Dorman suspension control arm need a separate ball joint?
No. This Dorman 521-891 arm comes with the ball joint and rubber bushings pre-installed, and mounting hardware is included. A grease fitting is not included.
Are the Dorman control arm bushings rubber?
Yes. The bushings on this lower control arm are rubber and come pre-installed. The arm itself is aluminum.
What size is the ball joint stud on this Dorman control arm?
The ball joint has a 14 mm thread diameter and a pinch stud type. The mounting hole on the arm measures 12.1 mm.
Does Dorman 521-891 replace the 13334022 control arm?
Yes. 13334022 is one of the numbers Dorman 521-891 replaces. The Interchange line lists the rest.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.