Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS76180
$70.99
(You save)
Bring back tight, quiet steering with the Mevotech Supreme control arm CMS76180, a front right lower control arm and ball joint assembly that installs as a direct-fit replacement for the 2011-2014 Mazda 2. This Mevotech Supreme lower control arm locates the front wheel and, through its integrated ball joint, lets the suspension travel and the wheel steer while helping keep alignment angles in check.
Stamped steel construction: built to OE-level tolerances for a strong, dependable arm.
Resists corrosion: a protective surface treatment guards against rust build-up.
Ready to install: the arm and ball joint come pre-assembled, and Labor Saver designs and hardware help speed the job.
Durability tested: application-specific engineering backed by in-house and third-party durability testing.
As a Mevotech Supreme suspension control arm, it addresses a worn front right lower arm or ball joint. Common signs include clunking over bumps, loose or wandering steering, and uneven front tire wear; if a failed control arm or ball joint is the cause, this assembly replaces it. This listing covers the front right lower position—inspect the opposite side and replace worn arms in pairs for balanced handling.
What vehicles does the Mevotech Supreme CMS76180 fit?
It's a direct-fit replacement for the 2011-2014 Mazda 2. Check the Buyer's Guide tab to confirm your exact vehicle.
Is this a front or rear control arm?
It's the front right lower control arm and ball joint assembly.
What are signs my Mazda 2 lower arm or ball joint needs replacing?
Clunking over bumps, loose or wandering steering, and uneven front tire wear can point to a worn control arm or ball joint. Have the cause diagnosed before replacing.
Does this Mazda 2 control arm include the ball joint?
Yes. The ball joint comes pre-assembled in the arm, so you replace both as a single unit.
What is this control arm made of, and does it resist rust?
It uses stamped steel construction with a protective surface treatment that guards against rust build-up.
Write a Review
MEVOTECH
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS76180
Restore tight, controlled rear handling with the Mevotech Supreme control arm CMS301253, a direct-fit rear right upper control arm and ball joint assembly for the 2015-2024 Nissan Murano. This...
Get precise wheel location back with the Mevotech Supreme control arm, part number CMS90110 — a direct-fit replacement for the 2001-2003 Hyundai Santa Fe. This rear left upper control arm positions...
Keep your Daewoo Lanos's front suspension precisely located with the Mevotech Supreme control arm and ball joint assembly, MPN CMS90151. This Mevotech Supreme lower control arm installs as a...
Locate the front wheel and keep steering tight with the Mevotech Supreme control arm CMS50133, a front right lower suspension control arm and ball joint assembly built as a direct-fit replacement for...
Keep the front wheel precisely located and the steering responsive with the Mevotech Supreme control arm, part number CMS70104. This front left lower unit installs as a direct-fit replacement for the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
