Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Dorman 520-137 front left upper control arm with ball joint for the 1982-1983 Chevrolet Malibu and other vehicles links the left front wheel to the frame. This Dorman suspension control arm and ball joint assembly directly replaces the original on specific applications.
A clunk over bumps, loose steering or uneven front tire wear can mean this control arm or its ball joint is worn, though a worn tie rod end or sway bar link can also be behind them. This listing is one arm; the 1982-1983 Chevrolet Malibu takes one on this side, the front right is a separate part, and both sides are normally replaced together.
This Dorman suspension control arm is listed for a wide range of Chevrolet, GMC, Buick, Oldsmobile, Pontiac and Isuzu models, including the 1995-2005 Chevrolet Blazer and the 1992-2004 GMC Jimmy. Driving something not named here? Look up your year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with the ball joint and bushings installed, plus mounting hardware. A grease fitting is not included.
Interchange: 810-94986B · 623.66021 · 12543947-L
TC5439 · CA12297 · 12376265 · 12543947 · 12546747 · 19133653 · 19416902 · 31022770 · CK620250 · CK620261 · RK620261 · FA4203 · GS50102 · CMS50102 · 2605330 · 8CB50056 · SRK620261 · X07CJ7152 · JTC1961
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this front left upper Chevy Malibu control arm right for a 1982-1983 model?
Yes, Dorman 520-137 is the front left upper control arm for the 1982-1983 Chevrolet Malibu; the front right side is a separate part.
Are the Dorman control arm bushings already installed?
Yes, the ball joint and rubber bushings come pre-installed, and the ball joint is pre-greased. Mounting hardware is included; a grease fitting is not.
What is this Dorman control arm made of?
The control arm is steel, in a casting/forged type, with rubber bushings. Additional coatings give it rust and corrosion resistance.
What thread size does the ball joint stud on Dorman 520-137 use?
Dorman 520-137 has a threaded ball joint stud with a 14 mm thread diameter. The mounting hole measures 12.3 mm across.
Is 12376265 an interchange number for Dorman 520-137?
Yes, 12376265 is on the interchange list for Dorman 520-137, along with the other numbers printed at the bottom of this page.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.