Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-049
$266.99
(You save)
Help keep the front suspension tracking smoothly and predictably with the Dorman control arm 520-049. This front left lower assembly is a direct replacement for the original equipment on the 2017-2025 Chrysler Pacifica, 2020-2025 Chrysler Voyager and 2021-2025 Chrysler Grand Caravan.
This Dorman suspension control arm and ball joint assembly arrives with its ball joint and bushings already installed, so the repair is handled as one unit. The control arm connects the wheel assembly to the vehicle's chassis and lets the suspension travel up and down. The ball joint serves as the pivot point for steering. If worn bushings or a loose ball joint in the original arm are causing clunking, wandering steering or uneven tire wear, this assembly replaces both in a single piece. See the Buyer's Guide tab for engine-specific application details.
Direct replacement: Designed to take the place of the original assembly on the listed applications.
Complete repair: Each assembly comes with a pre-installed ball joint and bushings, which helps save time and labor.
Quality engineering: Put through industry-leading testing aimed at a smooth, stable ride with directional stability and predictable dynamics.
Durable design: Additional coatings help the assembly resist rust and corrosion.
It fits the front left lower position on Chrysler models including the 2017-2025 Chrysler Pacifica. The Buyer's Guide tab shows every listed application and engine.
What does a Dorman lower control arm do?
It connects the wheel assembly to the vehicle's chassis, which lets the suspension move up and down while holding the wheel in position. The ball joint acts as the steering pivot.
What comes with this assembly?
The control arm arrives with the ball joint and bushings already installed, which helps save time and labor during the repair.
What are signs the control arm may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and worn bushings or play in the ball joint. Have the suspension inspected to confirm the cause.
Is this control arm protected against rust?
Yes. Dorman applies additional coatings intended to help the assembly resist rust and corrosion.
Write a Review
Dorman
Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-049
Help keep the front end steady and predictable with the Dorman control arm 520-520, a front right lower control arm with ball joint built to directly replace the original on the 1994-1999 Nissan...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
Replace a worn front upper arm in one job with the Dorman control arm with ball joint, part number 520-084, a direct replacement for the original equipment on the 1989-1995 Toyota Pickup, 1993-1998...
This suspension control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications. An industry-leading evaluation process ensures a smooth ride,...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
