Delphi TC6737 rear upper control arm with ball joint for the 1998-2002 Honda Accord and other vehicles links the wheel to the body and pivots on its ball joint. This control arm and ball joint assembly replaces the arm and the joint as one piece.
- Ball studs machined to micron tolerances for durability and smooth joint operation
- 100% crack detection and ultrasonic flaw detection on each control arm
- Robot-welded arm for consistent performance and quality
- Anti-corrosion protection applied to each part
- Tested below -40 degrees C and over 120 degrees C, and exposed to 720 hours of salt spray
Quick facts
- Part: Delphi TC6737 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 1998-2002 Honda Accord and other vehicles
- Position: Rear upper
- Condition: New
A clunk over bumps or uneven tire wear can mean the arm or its ball joint is worn, though other suspension parts cause the same signs, so pin down the cause first. With the engine off, look the arm over for cracks and rust; a shop can check ball joint play on a lift.
Fits
Besides the Accord, the vehicles it fits include the 1996-2004 Acura RL and the 1999-2003 Acura TL. Driving something else? Open the "Vehicles it fits" section and check your exact model and engine there. The rear upper position takes one arm on each side of the axle; this listing is a single arm, and the other side of that axle is normally done at the same time.
Specifications
Fit and size
- Position: Rear upper
- Quantity per vehicle: 2
Build and materials
- Type: control arm with ball joint assembly
- Condition: New
Interchange: 930030114 · RK100067 · CMS601192 · JTC1820
This part cross-references / interchanges with the following part numbers:
930030114, RK100067, CMS601192, JTC1820
Frequently Asked Questions
Is this Honda Accord control arm right for a 1998-2002 Accord?
Yes. Delphi TC6737 is a rear upper control arm with ball joint made for the 1998-2002 Honda Accord. Use the "Vehicles it fits" section to check other models.
Is this a Honda Accord upper control arm for the front or the rear of a 1998-2002 Accord?
It is a rear upper arm. Delphi TC6737 goes in the rear upper position, and the 1998-2002 Honda Accord takes two, one on each side of the axle.
How are Delphi control arms inspected for flaws?
Each Delphi control arm goes through 100% crack detection and ultrasonic flaw detection, and the arms are robot welded for consistent quality.
What can a worn ball joint on this control arm sound or feel like?
A clunk over bumps or uneven tire wear can mean the arm or its ball joint is worn. A shop can measure ball joint play safely.
Does Delphi TC6737 replace RK100067?
Yes. RK100067 is among the other-brand numbers that Delphi TC6737 replaces. The full cross-reference list is on the Interchange line.
