Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:526-675
Dorman 526-845 front left lower control arm with ball joint for the 2017-2025 Audi A4 and other vehicles links the wheel to the suspension. This Dorman control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications.
A clunk over bumps, loose or wandering steering or uneven front tire wear can mean a worn control arm or ball joint. Sway bar links, tie rods, struts or tires can be behind these signs too, so find the cause before you buy. This listing is one arm for the front left; the front right is a separate part, and the two are normally replaced together.
The fitment covers a wide range of Audi models, led by the 2017-2025 Audi A4, the 2021-2025 Audi A5 and the 2021-2025 Audi RS5. If your car is not one of those, open the Buyer's Guide tab and look up your exact model and engine.
Fit and size
Build and materials
One control arm with the ball joint and bushings installed. Mounting hardware is included.
Interchange: CA12943 · 4CB70169 · RK623724 · GS701133 · CMS701133 · 2608509 · 8W0407693B
This part cross-references / interchanges with the following part numbers:
Is this Audi A5 control arm listed for 2021-2025 cars?
Yes. Dorman 526-845 is listed for the 2021-2025 Audi A5, the 2021-2025 Audi RS5 and the 2017-2025 Audi A4 as the front left lower arm. For another model, use the Buyer's Guide tab.
Is this the lower control arm for the left side of a 2021-2025 Audi A5?
Yes. Dorman 526-845 is the front left lower arm for the 2021-2025 Audi A5. The front right takes its own arm, which is ordered separately.
Are the Dorman control arm bushings already installed?
Yes. The bushings and the ball joint come pre-installed on this assembly. The bushings are rubber and steel, and a grease fitting is not included.
How big is the ball joint stud on this Dorman lower control arm?
The stud on Dorman 526-845 is threaded, with a 14 mm thread diameter and a 42 mm stud length.
What are the overall dimensions of this control arm?
This front left lower control arm measures 237 mm at its maximum length and 288.5 mm at its maximum width. The mounting hole is 12.2 mm in diameter.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.