Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861045
$102.99
(You save)
Keep your Toyota Tacoma's front suspension tracking true with the Mevotech Supreme Suspension Control Arm and Ball Joint Assembly (CMS861045). This front right upper control arm positions the wheel and locates the suspension, pivoting on its bushings while the integrated ball joint allows steering and suspension travel. It installs as a direct-fit Toyota Tacoma control arm for the 2005-2015 Tacoma. Worn bushings or a loose ball joint can cause clunking, uneven tire wear, and wandering steering; if the original arm or its ball joint is the cause, this assembly replaces both in one part.
Quick, easy installation: secures the ball joint to the vehicle with the part-specific slotted castle nut and snap cotter pin provided.
Resists corrosion: a protective surface treatment helps limit rust buildup for longer service life.
Precise engineering: engineered in-house with application-specific upgrades built for high-usage passenger vehicles, SUVs, fleets and working trucks.
Rigorously tested: backed by extensive in-house and third-party durability testing.
Sold as one front right upper control arm and ball joint assembly with the ball joint pre-installed, so there is no separate press-in step.
Yes — it's a direct-fit replacement for the 2005-2015 Toyota Tacoma in the front right upper position. See the Buyer's Guide tab to confirm your exact engine and trim.
Is the ball joint included?
Yes. This is a complete control arm and ball joint assembly, so the ball joint comes pre-installed — there's no need to press one in separately.
Does it come with mounting hardware?
It includes the part-specific slotted castle nut and snap cotter pin used to secure the ball joint. Consult the vehicle service information for any additional fasteners and torque specs.
What are the signs my control arm or ball joint may need replacing?
Clunking over the front end, uneven tire wear, loose or wandering steering, and cracked bushings are common signs. Diagnose the cause before replacing.
Should I replace both sides at the same time?
This listing is for one front right upper assembly. Replacing the left and right sides together is a good practice for balanced, even suspension performance.
Write a Review
Mevotech Supreme
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861045
Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS70110. Fits: Audi A6, Audi A6 Quattro, Audi A8 Quattro, Audi S6, Audi S8, Volkswagen Phaeton.
Renew tired front-end handling with the Mevotech Supreme control arm and ball joint assembly (P/N CMS101145). This integrated unit drops in as a direct-fit replacement for the 2005-2009 Land Rover...
Firm up steering response and restore tight front-end geometry with the Mevotech Supreme Control Arm with Ball Joint CMS251267 — a front left upper control arm and ball joint assembly that installs...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
