MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK622036
$146.99
(You save)
Tighten up steering response and quiet a worn front corner with the MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly RK622036. It drops in as a direct-fit front left lower replacement for the 2011-2020 Toyota Sienna, arriving as a complete arm with the ball joint and bushings already installed so you locate the knuckle and set alignment in one job.
Carbon-fiber-reinforced bearing: paired with induction-hardened studs to reduce socket friction versus typical non-reinforced bearings for longer socket life.
Induction-hardened studs: hardened to maximize strength, resist breakage, and improve fatigue life.
Greaseable socket: lets fresh lubricant flush out contaminants to reduce corrosion and wear, making maintenance easy.
Pre-installed dust boot seal & premium bushings: the boot keeps dirt and water out, while bushings are set with optimized stiffness to inhibit noise for a comfortable ride.
Specially-engineered coatings are applied to metal surfaces to inhibit deterioration from rain, snow, salt, and road grime, and a laser-etched ID marks genuine MOOG quality. Precision tolerances aid installation and alignment, and all necessary mounting hardware is included.
It is a direct-fit front left lower control arm and ball joint assembly for the 2011-2020 Toyota Sienna. See the Buyer's Guide tab to confirm the exact match for your vehicle.
Which position is this control arm for?
This assembly is the front left (driver-side) lower control arm with the ball joint pre-installed.
Does it come with the ball joint and bushings?
Yes. The ball joint and premium bushings come pre-installed, and MOOG includes all necessary mounting hardware for installation.
Is the ball joint greaseable?
Yes. It features a greaseable socket, letting fresh lubricant flush out contaminants to reduce corrosion and wear and make maintenance easier.
What are signs this control arm assembly may need replacing?
Common signs include clunking or knocking over the front end, loose or wandering steering, uneven tire wear, or torn bushings and a worn ball joint. Diagnose the cause before replacing.
Write a Review
MOOG
MOOG Chassis Products Suspension Control Arm and Ball Joint Assembly P/N:RK622036
MOOG RK624063 Suspension Control Arm and Ball Joint Assembly for BMW 530i xDriveSuspension Control Arm and Ball Joint AssemblyMOOG premium control arms for foreign and domestic nameplates are...
MOOG RK623832 Suspension Control Arm and Ball Joint Assembly for Chevrolet Silverado 1500MOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
MOOG RK621001 Front Right Upper Forward Suspension Control Arm and Ball Joint Assembly for Audi Q5Front Right Upper Forward Suspension Control Arm and Ball Joint AssemblyMOOG premium control arms for...
MOOG RK622609 Suspension Control Arm and Ball Joint Assembly for Land Rover Range Rover SportMOOG premium control arms for foreign and domestic nameplates are engineered for structural strength and...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
