Front Lower Control Arm Bushing for 2006-2011 Chevrolet HHR & More - Delphi TD4486W

$23.99
WARNING:California Proposition 65▾
Delphi Suspension Control Arm Bushing TD4486W
Delphi Suspension Control Arm Bushing TD4486W - view 2
Delphi Suspension Control Arm Bushing TD4486W - view 3
Delphi Suspension Control Arm Bushing TD4486W - view 4
Delphi Suspension Control Arm Bushing TD4486W - view 5
Delphi Suspension Control Arm Bushing TD4486W
Delphi Suspension Control Arm Bushing TD4486W - view 2
Delphi Suspension Control Arm Bushing TD4486W - view 3
Delphi Suspension Control Arm Bushing TD4486W - view 4
Delphi Suspension Control Arm Bushing TD4486W - view 5

Vehicles this part fits
    Part number: TD4486W
    UPC: 689604332184
    Condition: New
    Weight: 0.50 LBS
    Item Package Quantity: 1
    $23.99
    Adding to cart… The item has been added

    Have questions?

    Ask an Expert
    Delphi Suspension Control Arm Bushing P/N:TD4486W
    Delphi Suspension Control Arm Bushing P/N:TD4486W
    $23.99
    $23.99

    Cushion the front lower control arm's forward pivot and help isolate road vibration with the Delphi Control Arm Bushing TD4486W. It is a direct-fit replacement for many vehicles, among them the 2006-2011 Chevrolet HHR, 2005-2010 Chevrolet Cobalt and 2007-2010 Pontiac G5; see the "Vehicles it fits" section for the full list. This suspension control arm bushing seats in the FRONT LOWER FORWARD position, locating the control arm while damping the noise and vibration that pass from the road into the chassis.

    • Designed to OE standards: Delphi applies its OE expertise to the aftermarket steering portfolio, using dimensional and material analysis for close compatibility between the OE and aftermarket part.
    • Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt-spray exposure.
    • Built to reduce noise and vibration: manufactured for consistent service life and to reduce noise and vibration.
    • Ready to install: Delphi includes the necessary accessories for a complete job.

    Worn control arm bushings can show up as clunks over bumps, imprecise steering, or uneven tire wear. If a failed bushing is the cause, this Delphi unit replaces it. Bushings on paired suspension arms wear at a similar rate, so inspect both sides.

    Interchange: 60640052 · 25837418 · K200361 · MS50403 · JBU1479

    This part cross-references / interchanges with the following part numbers:

    60640052, 25837418, K200361, MS50403, JBU1479

    Frequently Asked Questions

    Is this the right control arm bushing for a 2006-2011 Chevrolet HHR?

    Yes. It is a direct-fit replacement for the 2006-2011 Chevrolet HHR in the front lower forward position. See the "Vehicles it fits" section for every listed vehicle.

    Where does this bushing mount on the vehicle?

    It seats in the FRONT LOWER FORWARD control arm position, where it locates the arm and helps isolate road-borne noise and vibration from the chassis.

    What are signs this control arm bushing may need replacing?

    Clunking over bumps, vague or wandering steering, and uneven tire wear can point to worn bushings. Have the cause diagnosed, since these symptoms can have other sources.

    Does this control arm bushing include installation accessories?

    Yes. Delphi includes the necessary accessories for a complete job, so you have what's needed to finish the installation.

    Should I replace the bushings on both sides?

    It's good practice. Paired suspension arms wear at a similar rate, so inspecting and replacing both sides helps keep handling balanced.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review

    Related Products

    !