Quiet down that clunky, wandering rear end with the Mevotech Supreme Suspension Control Arm Bushing MS104131, the direct-fit Saab 9-3 control arm bushing for the 2003-2011 SAAB 9-3. It presses into the rear lower control arm to locate the arm and cushion road inputs, keeping the suspension geometry in check while isolating vibration and impact harshness from the chassis. See the "Vehicles it fits" section for engine-level details on your specific 9-3.
- High-grade natural rubber construction for increased durability
- OE-quality fit and performance as a control arm bushing replacement
- Rear lower position — installs in the rear lower control arm
Worn or cracked bushings can show up as clunking over bumps, imprecise handling, uneven tire wear, or a loose, wandering feel. If a failed bushing is the cause, this suspension control arm bushing replaces it and helps restore proper location and cushioning of the control arm. Inspecting and servicing both sides at once is good practice for balanced, even suspension behavior.
Interchange: 19383963 · CGS104131 · TD857W · TD895W · BU30355 · 2GS104131 · GS104131 · 10131401 · 12756395 · X43BU0078
This part cross-references / interchanges with the following part numbers:
19383963, CGS104131, TD857W, TD895W, BU30355, 2GS104131, GS104131, MS104131, 10131401, 12756395, X43BU0078
Frequently Asked Questions
What vehicles does the Mevotech MS104131 fit?
It is a direct-fit replacement for the 2003-2011 SAAB 9-3. Check the "Vehicles it fits" section to confirm the exact engine and configuration for your vehicle.
Where does this control arm bushing install?
It is the rear lower position bushing, pressing into the rear lower control arm to locate the arm and cushion road inputs.
What is this bushing made of?
It uses high-grade natural rubber construction for increased durability, engineered for OE-quality fit and performance.
What are the signs I may need to replace this bushing?
Common signs include clunking over bumps, imprecise or wandering handling, uneven tire wear, and a loose suspension feel. Diagnose the cause before replacing.
Should I replace both sides at the same time?
Replacing the bushings on both sides together is good practice for balanced, even suspension behavior, though it is recommended rather than strictly required.
