Mevotech Supreme Suspension Control Arm Bushing P/N:MS254278
Keep your front upper control arm pivoting on fresh rubber with the Mevotech Supreme MS86406, a 1995-2003 Toyota Tacoma control arm bushing built from high grade natural rubber. It is a direct-fit replacement for the front upper control arm on the 1995-2003 Toyota Tacoma. See the Buyer's Guide tab for engine and trim details.
A suspension control arm bushing sits between the control arm and its mounting point. It cushions the arm as it pivots with suspension travel and helps isolate road vibration from the chassis. Mevotech builds the MS86406 for OE quality fit and performance.
Signs that a worn bushing may need replacing include clunking or knocking over bumps, loose or wandering steering, uneven tire wear, and visibly cracked, torn or separated rubber. Other suspension and steering components can cause similar symptoms, so diagnose the cause before you replace parts. Have the wheel alignment checked after installation.
Interchange: 602.44060
60244060 · 19381923 · BGS86406 · TD4332W · BC74299 · BC74299PR · BU05017 · BU19430 · IK200125 · K200125 · 1K200125 · GS86406 · 1060468 · 16910 · 5601085 · JBU969 · 4863235070
This part cross-references / interchanges with the following part numbers:
Will this control arm bushing fit my 1995-2003 Toyota Tacoma?
The MS86406 is listed for the 1995-2003 Toyota Tacoma in the front upper control arm position. Check the Buyer's Guide tab for engine and trim details for your truck.
What is the MS86406 bushing made of?
Mevotech builds the MS86406 from high grade natural rubber. The manufacturer states this material is used for increased durability.
What are signs a control arm bushing may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and cracked or torn rubber. Other suspension parts can cause similar symptoms, so diagnose the cause before replacing anything.
Where does this bushing install?
It is cataloged for the front upper control arm on the listed applications. There it cushions the arm's pivot point as the suspension moves.
Should I get an alignment after replacing it?
Replacing control arm bushings can affect suspension geometry, so it is good practice to have the alignment checked afterward. Follow the vehicle service information for installation and torque procedures.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.