Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4248W
$21.99
(You save)
Keep the front sway bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit TD4248W, a direct-fit front stabilizer bar bushing kit for the 1998-2003 Toyota Sienna. The bushings cushion the front stabilizer bar where it mounts to the chassis, controlling body roll and helping keep the bar working as designed. Worn, cracked, or hardened original bushings often show up as clunking or rattling from the front during cornering and over uneven pavement — if the stabilizer bar bushings are the cause, this kit replaces them.
Delphi OE expertise: Delphi's OE safety technology is fitted to millions of vehicles worldwide, and that expertise carries into its aftermarket steering and suspension portfolio.
Tested to the extreme: validated for OE performance from below -40°C to over 120°C and through 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Designed to OE standards: manufactured for consistent life and to reduce noise.
Ride quality: designed to help restore the vehicle's smooth ride.
What vehicle does the Delphi TD4248W bushing kit fit?
It is a direct-fit front stabilizer bar bushing kit for the 1998-2003 Toyota Sienna. Check the Buyer's Guide tab to confirm the fit for your vehicle.
What is a stabilizer bar bushing kit and what does it do?
It supplies the bushings that cushion the front stabilizer (sway) bar where it mounts to the chassis, helping locate the bar and control body roll during cornering.
What are the signs my front sway bar bushings may need replacing?
Clunking or rattling from the front during cornering or over bumps, plus cracked or hardened bushings, are common signs. Diagnose the cause before replacing, since other parts can make similar noises.
How durable are these Delphi bushings?
Delphi validates them for OE performance from below -40°C to over 120°C and through 720 hours of salt spray, and they are manufactured for consistent life and to reduce noise.
Which part numbers does the TD4248W cross-reference?
It interchanges with 101-6362, 48815-AE010, BSK74049, K90546, MK90546, and JBU1046.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4248W
Quiet down front-end rattle and keep the front stabilizer bar located precisely with the Delphi Suspension Stabilizer Bar Bushing Kit TD4050W. It installs as a direct-fit replacement for the front...
Quiet stabilizer-bar rattle and help keep the rear sway bar properly located with the Delphi Sway Bar Bushing Kit TD922W, a rear-position replacement cataloged for the 2006-2011 Land Rover Range...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Quiet down front-end rattle and keep your stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4635W. It installs as a direct-fit replacement on the front of the 2004-2010...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
