Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4107W
$10.99
(You save)
Keep the rear stabilizer bar located and cushioned where it clamps to the frame with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4107W). These rear-to-frame bushings wrap the sway bar and isolate it from the chassis, helping quiet clunks and keeping the bar working as intended through cornering. It's a direct-fit replacement for the 2005-2006 Chevrolet Equinox, the 2006 Pontiac Torrent, and the 2002-2009 Saturn Vue — see the Buyer's Guide tab for engine-level detail.
Designed to OE standards: Delphi builds this stabilizer bar bushing kit to match the original components.
Manufactured for consistent life: produced to deliver steady service over time.
Made to reduce noise: the bushings are manufactured to help cut squeaks and rattles from the bar-to-frame connection.
OE-level validation: Delphi parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
If worn bushings are the source of your rattle or vague bar movement, replacing them helps restore the vehicle's smooth ride. Inspect and replace bushings on both sides together for balanced results.
It cushions the rear stabilizer (sway) bar where it mounts to the frame, isolating it from the chassis and helping the bar work as intended during cornering.
Where do these bushings mount?
This is a rear-to-frame kit — the bushings clamp the stabilizer bar to the frame at the rear.
Which vehicles does the TD4107W fit?
It's a direct-fit replacement for the 2005-2006 Chevrolet Equinox, the 2006 Pontiac Torrent, and the 2002-2009 Saturn Vue. See the Buyer's Guide tab for engine-level detail.
What are signs the sway bar bushings may need replacing?
Clunks or rattles over bumps, squeaking from the bar mounts, or vague, loose handling in corners can signal worn bushings. Diagnose the cause before replacing.
Should I replace both sides at once?
Yes, it's best practice to replace the bushings on both sides together so the stabilizer bar is supported evenly.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4107W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
